Emerson 2120 Quick Start Manual page 16

Quick Start Guide

10.6 Drinking water approval

Rosemount Measurement Limited, Slough, UK confirms that the wetted parts of

the Rosemount 2120 Vibrating Liquid Level Switches are suitable and approved

for use in potable water.

The wetted parts of the vibrating level switches executed in:

Stainless steel (option code D) and Alloy C / Alloy C-276 (option code C) with

Flanged, NPT thread, BSPT(R) thread, or Tri Clamp process connections, are in

accordance with the requirements of DVGW - Worksheet W270.The materials

used are classified as toxicologically and microbiologically safe.

10.7 Ordinary location certifications

Ordinary location certification for FM

G5 Project ID: 3021776

The switch has been examined and tested to determine that the design meets

basic electrical, mechanical, and fire protection requirements by FM, a

nationally recognized testing laboratory (NRTL) as accredited by the Federal

Occupational Safety and Health Administration (OSHA).

Ordinary location certification for CSA

G6 Certificate Number: 06 CSA 1805769

The switch has been examined and tested to determine that the design meets

basic electrical, mechanical, and fire protection requirements by CSA, a

nationally recognized testing laboratory as accredited by the Standards

Council of Canada (SCC). Single seal.

10.8 Canadian Registration Number

Certificate number: CRN 0F04227.2C

The requirements of CRN are met when a Rosemount 2120 CSA-approved

vibrating fork level switch model is configured with 316/316L stainless steel

(1.4401/1.4404) process-wetted parts and either NPT threaded or 2 to 8-in.

ASME B16.5 flanged process connections.

10.9 Safety Integrity Level (SIL) certification

The Rosemount 2120 has been independently certified to IEC 61508 as required

by IEC 61511. Certification was conducted by Exida.

The Rosemount 2120 is SIL2-certified, and is SIL3 capable.

10.10 Hazardous locations certifications

Note

A

certified isolating amplifier to IEC 60947-5-6 is required for intrinsic safety if the

NAMUR electronics is used in a hazardous area installation

A certified intrinsically safe barrier is required for intrinsic safety if the 8/16 mA

electronics is used in a hazardous area installation

16

December 2016