Siemens SIPART Series Operating Instructions Manual page 39
Electropneumatic positioners with and without hart
Hide thumbs
Also See for SIPART Series:
- Compact operating instructions (35 pages) ,
- Operating instructions manual (44 pages)
Table of Contents
1. Install the clamping pieces
2. Slide the pick-up bracket
3. Set the necessary length.
4. Tighten the screws
5. Fix the pre-installed carrier pin
6. Set the stroke value. Use the value specified on the nameplate of the actuator for this
SIPART PS2 with and without HART
Operating Instructions, 10/2013, A5E00074631-11
⑰
socket cap screws
Figure 4-1
Pick-up bracket
⑰
⑭
washer
and hexagon nut
Figure 4-2
Lever with carrier pin
purpose. If none of the values on the scale matches the value on the actuator nameplate,
select the next higher scaling value. Position the pin center
the scale. If you need the value of actuator travel after initialization in mm: ensure that the
configured stroke value matches the value of the "3.YWAY" parameter.
③
on the actuator spindle. Use spring lock washers
for this purpose.
②
into the milled recesses of the clamping pieces
so that you can still shift the pick-up bracket.
④
to the lever
⑱
for this purpose.
4.2 Mounting the linear actuator
⑥
. Use the flat washer
④
on the matching value of
Installing/mounting
⑯
and
③
.
⑫
, spring lock
37
Table of Contents
