11.Press the
12.The initialization process is automatically resumed. Initialization steps "RUN1" to "RUN5"
Aborting the manual initialization process
1. Press the
2. Exit the "Configuration" mode. To do this, press the
3. The software status is displayed.
4. After releasing the
See also
Overview of device components (Page 23)
SIPART PS2 with and without HART
Operating Instructions, 10/2013, A5E00074631-11
button. The current position of the actuator is applied.
are output in the bottom line of the display. The following display indicates that the
initialization has been completed successfully:
button. The display shows the "INITM" parameter. The positioner is in the
"Configuration" mode.
button, the positioner is in "P manual mode". "P manual mode"
means that the positioner has not been initialized.
7.5 Commissioning part-turn actuators
button for at least 5 seconds.
Commissioning
137