Emerson Copeland Scroll XFAL Series Installation And Reference Manual
  1. Manuals
  2. Brands
  3. Emerson Manuals
  4. Heat Pump
  5. Copeland Scroll XFAL Series
  6. Installation and reference manual

Emerson Copeland Scroll XFAL Series Installation And Reference Manual

1.5 to 6 hp outdoor refrigeration unit
Hide thumbs
Table of Contents

Quick Links

Copeland Scroll
Installation and reference manual
Models:
XFAL, XFAM, XFAP
1.5 to 6 HP
Outdoor Refrigeration Unit
™
Table of Contents
loading

Related Manuals for Emerson Copeland Scroll XFAL Series

Summary of Contents for Emerson Copeland Scroll XFAL Series

  • Page 1 Copeland Scroll Outdoor Refrigeration Unit ™ Installation and reference manual Models: XFAL, XFAM, XFAP 1.5 to 6 HP...

  • Page 2: Table Of Contents

    6.20.3. Liquid Line Solenoid Control ....13 6.21. Enhanced Vapor Injection (EVI) for Low Temperature Units..........13 6.21.1. Low Temp EVI Discharge Line Temperature Protection Mode....13 6.21.1.1. Low Temp EVI Discharge Line Temperature Protection Error Handling ........ 14 © 2016 Emerson Climate Technologies, Inc. 552-7018-00...
  • Page 3 NOTICE NOTICE is used to address practices not related to personal injury. CAUTION, without the safety alert symbol, is used to address practices CAUTION not related to personal injury. © 2016 Emerson Climate Technologies, Inc.
  • Page 4 • Refrigerant compressors must be employed only for their intended use. • install, commission and maintain this equipment. • • All valid standards and codes for installing, servicing, and maintaining electrical and refrigeration equipment must be observed. © 2016 Emerson Climate Technologies, Inc.

  • Page 5: Introduction

    Discharge line temperature control is provided by enhanced vapor injection (EVI). Medium temperature XFAM units (0°F to +45°F saturated suction) include all the standard features. 2. Nomenclature – – – Base Model Electrical Bill of Material © 2016 Emerson Climate Technologies, Inc.

  • Page 6: Electrical/Physical Data

    For ground mounting, the units should be which this particular unit will need to operate. Follow the placed on a level solid concrete slab with rubber strips ASHRAE guidelines for proper piping practice. © 2016 Emerson Climate Technologies, Inc.

  • Page 7: Quick Setup Guide

    AE5-1412 R1 5. Quick Setup Guide © 2016 Emerson Climate Technologies, Inc.

  • Page 8: User Interface

    Flashing Fast access menu (Viewing set points and measured values) Browsing the alarm menu Flashing New alarm occurred An alarm is occurring In defrost or evap fan drip time when ON Evaporator fans enabled © 2016 Emerson Climate Technologies, Inc.

  • Page 9: Button Descriptions And Key Combinations

    Pon message is displayed. NOTE: The set value is stored even when the procedure is exited by waiting for the time-out to expire. NOTE: If a menu does not have any parameters available, noP will be displayed © 2016 Emerson Climate Technologies, Inc.

  • Page 10: Changing Clock Setting

     H t Not used R-448A  tU1 Line voltage (1-phase) R-449A  tU2 Line voltage (3-phase)  tU3 Line voltage (3-phase)  tA1 Current (1-phase)  tA2 Current (3-phase)  tA3 Current (3-phase) Menu  © 2016 Emerson Climate Technologies, Inc.

  • Page 11: Alarm Menu

    End label. the set and up button are pressed together to exit, the After 10 seconds the controller will restart and begin controller will resume normal operation. © 2016 Emerson Climate Technologies, Inc.

  • Page 12: Controller Startup

    There are no reliability issues in this For three seconds the controller will display the application. program number (EX: 100, 101, 200, etc.) The controller will then wait 6 seconds before turning on the compressor or any other device. © 2016 Emerson Climate Technologies, Inc.

  • Page 13: Crankcase Heater

    40% before turning off. When a fan first turns on it will run for 3 seconds at full speed before it begins modulating. Fans will run for at least © 2016 Emerson Climate Technologies, Inc.

  • Page 14: Defrost Controls

    If the discharge temperature goes above 250°F, the compressor trips off and the control displays an E44 error. The compressor cannot turn back on until the temperature drops below 170°F and has been off for 3 minutes. © 2016 Emerson Climate Technologies, Inc.

  • Page 15: Low Temp Evi Discharge Line Temperature Protection Error Handling

    6.21.4. Low Temperature Units With EVI TXV the mid coil and ambient sensor. Selection For use with low temperature units with EVI, Emerson If the DLT sensor fails and a mid-coil temperature sensor recommends a balanced port TXV because it offers a is available, the injection valve will be opened based on wider operating range for floating liquid temperatures.

  • Page 16: Incorrect Phase Sequence Protection (3 Phase Only)

    3 legs for 1 second, the controller will display E22 and shut the unit down (based on a parameter PiC) for 5 minutes and until the phase imbalance is corrected. © 2016 Emerson Climate Technologies, Inc.

  • Page 17: Fixed High Pressure Control

    This relay has a 5 Amp limit, up to 250V. The alarm contact will close in the event of an alarm or lockout. © 2016 Emerson Climate Technologies, Inc.

  • Page 18: Physical And Installation Requirements

    AE5-1412 R1 8. Physical and Installation Requirements Single Fan Unit 1.5-3 HP Dual Fan Unit 4- 6 HP Bottom View All Models Figure 1 © 2016 Emerson Climate Technologies, Inc.

  • Page 19: 2016 Emerson Climate Technologies, Inc

    Powers Crankcase Heater and Receiver ¼” Spade Connector 8A Relay Heater ¼” Spade Connectors (2) 5A Relay Dry (Switch Only) Alarm Contact Left Terminal – Defrost Termination Input 250VAC Max Right Terminal – L2 © 2016 Emerson Climate Technologies, Inc.

  • Page 20: 2016 Emerson Climate Technologies, Inc

    Other Connections Label Functions Remote Display Connection Connect + to + and – to - RS485 RS-485 Communications CANBUS Future Use B.BKP Future Use Hotkey programming (use with part # 043-0171-01 to reset control) © 2016 Emerson Climate Technologies, Inc.

  • Page 21: Wiring Diagrams

    AE5-1412 R1 9. Wiring Diagrams 052-7287-00 Low Temp 1-Phase 2.0-3.5 HP 1 Condenser Fan © 2016 Emerson Climate Technologies, Inc.

  • Page 22: 2016 Emerson Climate Technologies, Inc

    AE5-1412 R1 052-7287-01 Low Temp 1-Phase 4-5 HP 2 Condenser Fans © 2016 Emerson Climate Technologies, Inc.

  • Page 23: 2016 Emerson Climate Technologies, Inc

    AE5-1412 R1 052-7287-02 Medium Temp 1-Phase 1.5-3 HP 1 Condenser Fan © 2016 Emerson Climate Technologies, Inc.

  • Page 24: 2016 Emerson Climate Technologies, Inc

    AE5-1412 R1 052-7287-04 Medium Temp 3-Phase 4.5-6 HP 2 Condenser Fans © 2016 Emerson Climate Technologies, Inc.

  • Page 25: 2016 Emerson Climate Technologies, Inc

    AE5-1412 R1 052-7287-05 Low Temp 3-Phase 2-3 HP 1 Condenser Fans © 2016 Emerson Climate Technologies, Inc.

  • Page 26: 2016 Emerson Climate Technologies, Inc

    AE5-1412 R1 052-7287-13 Low Temp 3-Phase 4-6 HP 2 Condenser Fans © 2016 Emerson Climate Technologies, Inc.

  • Page 27: 2016 Emerson Climate Technologies, Inc

    AE5-1412 R1 052-7287-14 Medium Temp 3-Phase 1.5-3 HP 1 Condenser Fan © 2016 Emerson Climate Technologies, Inc.

  • Page 28: 2016 Emerson Climate Technologies, Inc

    AE5-1412 R1 052-7287-15 Medium Temp 1-Phase 4.5-5 HP 2 Condenser Fans © 2016 Emerson Climate Technologies, Inc.

  • Page 29: Refrigerant Liquid Temperature Valve Capacity Multiplier Correction Factors

    These factors include corrections for liquid refrigerant density and net refrigerating effect and are based on an average evaporator temperature of 0°F. However, they may be used for any evaporator temperature from - 40°F to + 40°F since the variation in the actual factors across this range is insignificant. © 2016 Emerson Climate Technologies, Inc.

  • Page 30: Alarm Codes

    Lockout compressor to pull excessive current Check start component wiring per diagram Open run circuit error/ Alarm Check run capacitor Check wires are properly routed lockout Lockout through controller current transducers per wiring diagram © 2016 Emerson Climate Technologies, Inc.

  • Page 31: 2016 Emerson Climate Technologies, Inc

    Replace faulty controller communication error clock Reload factory settings with the E82-E85 Configuration Errors Alarm Replace faulty controller hotkey EEPROM Memory Reload factory settings with the Lockout Replace faulty controller Error hotkey © 2016 Emerson Climate Technologies, Inc.

  • Page 32: Sensor Values

    12.73 14.4 1.08 10.79 12.8 0.998 9.20 11.6 0.937 7.87 10.4 0.868 6.77 9.46 0.816 5.85 8.47 0.758 5.09 4.45 3.87 3.35 2.92 2.58 2.28 2.02 1.80 1.59 1.39 1.25 1.12 1.01 0.92 0.83 © 2016 Emerson Climate Technologies, Inc.

  • Page 33: Parameters

    Lod / Remote Display visualization P1 - P7 Compressor Ambient temperature required to initiate low LAS / -40 - 230 ambient on time (°F) LMO / Low ambient minimum on time (sec) 0 - 255 © 2016 Emerson Climate Technologies, Inc.

  • Page 34: 2016 Emerson Climate Technologies, Inc

    Emerson Climate Technologies, Inc. and/or its affiliates (collectively "Emerson"), as applicable, reserve the right to modify the design or specifications of such products at any time without notice. Emerson does not assume responsibility for the selection, use or maintenance of any product.
  • Page 35 Emerson.com 2015ECT-53 R1 (4/17) Emerson, Copeland Scroll and CoreSense are trademarks of Emerson Electric Co. or one of its affi liated companies. ©2017 Emerson Climate Technologies, Inc. All rights reserved.

This manual is also suitable for:

Copeland scroll xfam seriesCopeland scroll xfap seriesCopeland scroll xfal-020z-cfvCopeland scroll xfal-020z-tfcCopeland scroll xfal-030z-tfcCopeland scroll xfal-035z-cfv ... Show all

Table of Contents