Dell S4820T Configuration Manual page 799
Hide thumbs
Also See for S4820T:
- Manual (60 pages) ,
- Installation manual (59 pages) ,
- Configuration manual (1128 pages)
Table of Contents
Creating an Input QoS Policy
To create an input QoS policy, use the following steps.
1.
Create a Layer 3 input QoS policy.
CONFIGURATION mode
qos-policy-input
Create a Layer 2 input QoS policy by specifying the keyword layer2 after the qos-policy-input
command.
2.
After you create an input QoS policy, do one or more of the following:
Configuring Policy-Based Rate Policing
Setting a dot1p Value for Egress Packets
Configuring Policy-Based Rate Policing
To configure policy-based rate policing, use the following command.
•
Configure rate police ingress traffic.
QOS-POLICY-IN mode
rate-police
Setting a dot1p Value for Egress Packets
To set a dot1p value for egress packets, use the following command.
•
Set a dscp or dot1p value for egress packets.
QOS-POLICY-IN mode
set mac-dot1p
Creating an Output QoS Policy
To create an output QoS policy, use the following commands.
1.
Create an output QoS policy.
CONFIGURATION mode
qos-policy-output
2.
After you configure an output QoS policy, do one or more of the following:
Scheduler Strict — Policy-based Strict-priority Queueing configuration is done through scheduler
strict. It is applied to Qos-policy-output. When scheduler strict is applied to multiple Queues, high
queue number takes precedence.
Allocating Bandwidth to Queue
Specifying WRED Drop Precedence
Quality of Service (QoS)
799
Hide quick links:
Table of Contents
Troubleshooting
