Sample Configurations For Ospfv2; Basic Ospfv2 Router Topology - Dell S4820T Configuration Manual
Hide thumbs
Also See for S4820T:
- Manual (60 pages) ,
- Installation manual (59 pages) ,
- Configuration manual (1128 pages)
Table of Contents
•
View debug messages.
EXEC Privilege mode
debug ip ospf process-id [event | packet | spf | database-timers rate-limit]
To view debug messages for a specific OSPF process ID, use the debug ip ospf process-id
command.
If you do not enter a process ID, the command applies to the first OSPF process.
To view debug messages for a specific operation, enter one of the optional keywords:
– event: view OSPF event messages.
– packet: view OSPF packet information.
– spf: view SPF information.
– database-timers rate-limit: view the LSAs currently in the queue.
Example of Viewing OSPF Configuration
Dell#show run ospf
!
router ospf 4
router-id 4.4.4.4
network 4.4.4.0/28 area 1
!
ipv6 router ospf 999
default-information originate always
router-id 10.10.10.10
Dell#
Sample Configurations for OSPFv2
The following configurations are examples for enabling OSPFv2.
These examples are not comprehensive directions. They are intended to give you some guidance with
typical configurations.
You can copy and paste from these examples to your CLI. To support your own IP addresses, interfaces,
names, and so on, be sure that you make the necessary changes.
Basic OSPFv2 Router Topology
The following illustration is a sample basic OSPFv2 topology.
710
Open Shortest Path First (OSPFv2 and OSPFv3)
Hide quick links:
Table of Contents
Troubleshooting
