Dynamic Counters; Clearing Interface Counters - Dell S4820T Configuration Manual
Hide thumbs
Also See for S4820T:
- Manual (60 pages) ,
- Installation manual (59 pages) ,
- Configuration manual (1128 pages)
Table of Contents
Input 0 IP Packets, 0 Vlans 0 MPLS
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
Received 0 input symbol errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 IP Checksum, 0 overrun, 0 discarded
0 packets output, 0 bytes, 0 underruns
Output 0 Multicasts, 0 Broadcasts, 0 Unicasts
0 IP Packets, 0 Vlans, 0 MPLS
0 throttles, 0 discarded
Rate info (interval 100 seconds):
Input 00.00 Mbits/sec,
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 1d23h42m
Dynamic Counters
By default, counting is enabled for IPFLOW, IPACL, L2ACL, L2FIB.
For the remaining applications, Dell Networking OS automatically turns on counting when you enable the
application, and is turned off when you disable the application.
NOTE: If you enable more than four counter-dependent applications on a port pipe, there is an
impact on line rate performance.
The following counter-dependent applications are supported by Dell Networking OS:
•
Egress VLAN
•
Ingress VLAN
•
Next Hop 2
•
Next Hop 1
•
Egress ACLs
•
ILM
•
IP FLOW
•
IP ACL
•
IP FIB
•
L2 ACL
•
L2 FIB
Clearing Interface Counters
The counters in the show interfaces command are reset by the clear counters command. This
command does not clear the counters any SNMP program captures.
To clear the counters, use the following the command.
•
Clear the counters used in the show interface commands for all VRRP groups, VLANs, and physical
interfaces or selected ones. Without an interface specified, the command clears all interface counters.
EXEC Privilege mode
clear counters [interface] [vrrp [vrid] | learning-limit]
(OPTIONAL) Enter the following interface keywords and slot/port or number information:
472
0 packets/sec, 0.00% of line-rate
Interfaces
Hide quick links:
Table of Contents
Troubleshooting
