Table of Contents
4-6-8 On-the-fly marking: 2 sensors input
When trigger mode is set to Single trigger
ENCODER A IN (X13)
ENCODER B IN (X14)
TRIGGER IN (X5)
SHUTTER OPEN OUT (No.39)
READY OUT (Y5)
PROCESSING OUT (Y10)
LASING OUT (No.40)
Applied line speed
*1 : If TRIGGER IN (X5) is turned ON without proper detection of the line speed, warning E607 occurs.
*2 : When ENCODER B IN (X14) is input during the trigger processing operation, the line speed is updated after the
running trigger processing.
Item
Time
T1
0ms or more
T2
―
T3
Max. 10 sec.
T4
1 to 10 sec.
or
Not specified
(No time-out)
T5
―
T6
0ms or more
• It is recommended to set the sensors to detect the line speed and the trigger input position as close as possible to
reduce the difference between the detected line speed and the actual line speed at the marking.
126
Speed A
ON
T1
OFF
ON
T3
OFF
ON
T4
OFF
ON
OFF
ON
T2
OFF
ON
OFF
ON
OFF
Undefined *1
Speed A
Remarks
Turn on ENCODER A IN (X13) with the shutter opened.
Time for marking data creation. It varies depending on the quantity of the setting data.
If ENCODER B IN (X14) does not turn on within 10 seconds from turning on of ENCODER
A IN (X13), time-out error (E607) occurs when TRIGGER IN (X5) is input.
If TRIGGER IN (X5) is not turned on within the setting time-out period from turning on
ENCODER B IN (X14), time-out error (warning E607) occurs.
This time-out can be disabled by setting.
Time from when TRIGGER IN (X5) is turned on till when the workpiece comes to the
preset marking position.
ENCODER A IN (X13) for the next marking can be accepted after inputting ENCODER B
IN (X14).
ME-LPRH-SM-3
Speed B
Speed C
T6
T4
T5
T5
Speed B *2
T5
Speed C
Table of Contents
Troubleshooting
