Install The Middle Drive Backplanes And Drive; Cage - Lenovo ThinkSystem SR665 V3 User Manual
Hide thumbs
Also See for ThinkSystem SR665 V3:
- System configuration manual (80 pages) ,
- User manual (256 pages)
Table of Contents
c.
Carefully lift the backplane out of the drive cage.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Demo video
Watch the procedure on YouTube (2.5-inch)
Watch the procedure on YouTube (3.5-inch)
Install the middle drive backplanes and drive cage
Follow instructions in this section to install the middle drive backplanes and drive cage.
About this task
Attention:
• Read
"Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• The middle drive cage is supported on some server models with thermal requirements. See
rules" on page 59
to ensure that the server is under permitted ambient temperature and the correct heat
sink and system fans are used. If needed, replace your heat sink or system fan first.
–
"Processor and heat sink replacement (trained technician only)" on page 175
–
"System fan replacement" on page 264
Procedure
Step 1.
Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 2.
Install the drive backplane into the middle drive cage.
and
"Safety inspection checklist" on page 48
62.
.
Chapter 5
Hardware replacement procedures
to ensure that you
"Thermal
165
Table of Contents
