Table of Contents
278 Parameters
No.
Name/Value
31.30
Overspeed trip
margin
0.00 ... 10000.0
rpm
31.32
Emergency ramp
supervision
0...300%
Description
Defines, together with
30.11 Minimum speed
Maximum
speed, the maximum allowed speed of the motor
(overspeed protection). If
estimated speed exceeds the speed limit defined by
parameter
30.11
or
30.12
parameter, the drive trips on the
Example: If the maximum speed is 1420 rpm and speed trip
margin is 300 rpm, the drive trips at 1720 rpm.
Speed (90.01)
31.30
0
31.30
Overspeed trip margin.
Parameters
31.32 Emergency ramp supervision
Emergency ramp supervision
Speed change
rate, provide a supervision function for
emergency stop modes Off1 and Off3.
The supervision is based on either
• observing the time within which the motor stops, or
• comparing the actual and expected deceleration rates.
If this parameter is set to 0%, the maximum stop time is
directly set in parameter 31.33. Otherwise,
maximum allowed deviation from the expected deceleration
rate, which is calculated from parameters
or
23.23 Emergency stop time
deceleration rate (01.29) deviates too much from the
expected rate, the drive trips on
sets bit 8 of
06.17 Drive status word
If
31.32
is set to 0% and
stop ramp supervision is disabled.
See also parameter
21.04 Emergency stop
Maximum deviation from expected deceleration rate.
and
90.01 Motor speed for control
by more than the value of this
7310 Overspeed
Overspeed trip level
30.12
30.11
Overspeed trip level
delay, together with
31.32
23.11...23.19
(Off3). If the actual
73B0 Emergency ramp
2, and coasts to a stop.
31.33
is set to 0 s, the emergency
mode.
Def/FbEq16
30.12
500.00 rpm
or the
fault.
Time
See par.
46.01
and
31.33
0%
01.29
defines the
(Off1)
failed,
1 = 1%
Chapters
Table of Contents
