Installing A Drive; After Replacing A Drive - Bosch DSX-N1D8X4-12AT Installaton Manual

DSA E-Series (E2800 12-bay)

3.

4.

5.

6.

7.

Notice!

i

If you accidentally remove an active drive, wait at least 30 seconds, and then reinstall it. For

the recovery procedure, refer to the storage management software.

8.1.3

Install the replacement drive as soon as possible after removing the failed drive. Otherwise,

there is a risk that the equipment might overheat.

To install a drive:

1.

2.

3.

8.1.4

After replacing a drive, you must confirm that the new drive is working correctly.

To confirm that the drive is working correctly:

1.

The Power LED is on or blinking, and the

Attention LED is off.

The Power LED is off.

The Attention LED is on.

Bosch Security Systems B.V.

Open the cam handle, and slide out the drive slightly.

Wait 30 seconds.

Using both hands, remove the drive from the unit.

Place the drive on an antistatic, cushioned surface away from magnetic fields.

Wait 30 seconds for the software to recognize that the drive has been removed.

Open the cam handle.

Using two hands, insert the replacement drive into the open bay, firmly pushing until the

drive stops.

Slowly close the cam handle until the drive is fully seated in the midplane and the handle

clicks into place.

Note: Depending on your configuration, the controller might automatically reconstruct

data to the new drive. If the unit uses hot spare drives, the controller might need to

perform a complete reconstruction on the hot spare before it can copy the data to the

replaced drive. This reconstruction process increases the time that is required to

complete this procedure.

Check the Power LED and the Attention LED on the drive you replaced.

LED status

The new drive is working correctly

The drive might not be installed correctly.

Remove the drive, wait 30 seconds, and then

reinstall it.

The new drive might be defective. Replace it

with another new drive.

Note: When you first insert a drive, its

Attention LED might be on. However, the LED

should go off within a minute.

Installaton manual

Maintenance | en

Description

2021.05 | V3 | DOC

37