Adjusting The Image; Maximizing Light Output; Calibrating The Intelligent Lens System; Aligning The Image - Christie CP2415-Xe Installation And Setup Manual
Hide thumbs
Also See for CP2415-Xe:
- Technical reference (32 pages) ,
- Installation and setup manual (19 pages) ,
- User manual (104 pages)
Table of Contents
Adjusting the image
Learn how to adjust image geometry so it displays correctly.
Maximizing light output
To make sure optimal operation and peak screen brightness, use LampLOC
position when you install a new lamp.
Before running LampLOC
•
The anode yoke is in the correct position for the lamp type.
•
The lamp is on and the douser is open.
When you complete the LampLOC
the illumination system.
1. In the left navigation menu, select Lamp Settings > LampLOC.
2. Select Auto LampLOC.
Calibrating the Intelligent Lens System
On CP2415-Xe projectors, the Intelligent Lens System (ILS) is activated by default.
Use the Auto Calibrate feature of the ILS to find and compensate for motor backlash, and to determine
the movement range for the currently installed lens.
1. In the left navigation menu, select Image Settings > ILS File Setup.
2. From the ILS File list, select an available ILS file.
3. Select Auto Calibrate.
4. Select Continue.
The system performs the lens calibration.
Aligning the image
Aligning the image ensures when it is reflected from the digital micromirror device (DMD) it is parallel
and centered with the lens and screen.
You must complete this procedure before completing a boresight adjustment.
1. Verify the projector is properly positioned relative to the screen (on page 18).
2. Display a test pattern to analyze image focus and geometry.
Christie recommends using the Framing test pattern.
3. Perform a preliminary focus and, if available, a zoom adjustment with the primary lens.
Focus the center of the image first.
CP2415-Xe Installation and Setup Guide
020-103584-02 Rev. 1 (09-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
™
, verify the following:
™
adjustment, the lamp is centered and is the correct distance from
™
to adjust the lamp
32
Table of Contents
