Operation; Turning The Projector On; Turning The Projector Off; Projector States - Christie CP2415-Xe Installation And Setup Manual
Hide thumbs
Also See for CP2415-Xe:
- Technical reference (32 pages) ,
- Installation and setup manual (19 pages) ,
- User manual (104 pages)
Table of Contents
Operation
Learn how to operate the projector.
Turning the projector on
Learn how to turn the projector on.
1. Turn on the circuit breaker for the projector.
2. Press and hold the Power icon.
3. To ignite the lamp, press and hold the Light Bulb icon.
Turning the projector off
Learn how to turn the projector off.
1. Press and hold the Light Bulb icon to turn the lamp off.
Perform this step if you want the light source off but to keep the projector powered on.
Otherwise, proceed directly to step 2.
2. Press and hold the Power icon.
The projector enters a cool-down mode and the fans and electronics stay on for 10 minutes.
After this cool-down period, the projector enters Standby mode.
Projector states
Learn what occurs when you press the Power and Lamp icons and the tail light status.
Button pressed
Projector's current state
—
Enters Standby
power mode
(Flashing green on
the tail light)
Power On
Powers on to full
power (boot delay)
Power Off
No action
Lamp On
Power is on and
turns on the lamp
(boot delay)
CP2415-Xe Installation and Setup Guide
020-103584-02 Rev. 1 (09-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Power is on and the
Power is on and the
lamp is off
lamp is on
(Solid green on the
(Solid green on the
tail light)
tail light)
No action
No action
Powers off
Turns the lamp off
immediately
immediately; enter
cool-down mode
Immediately turns on
No action
the lamp
Cool-down mode
(Yellow/green
flashing on the tail
light)
Cancels cool down
and goes to full
power
No action
Cancels cool down
and immediately
turns on the lamp
30
Table of Contents
