Table of Contents
GE M
S
EDICAL
YSTEMS
D
FC091194, R
IRECTION
Section 4-2
General Procedures
4-2-1
Power ON/ Boot Up
4-2-1-1
Connecting Mains Power to the Unit
Never use a three-to-two prong adapter; this defeats the safety ground.
DANGER
SYSTEM REQUIRES ALL COVERS
CAUTION
Operate this unit only when all board covers and frame panels are securely in place. The covers
are required for safe operation, good system performance and cooling purposes.
NOTE:
Do not cycle the Circuit Breaker ON-OFF-ON in less than five -5- seconds. When turning OFF
the Circuit Breaker, the system should de-energize completely before turning the circuit breaker
ON.
NOTE:
When turning on a system from standby mode, it takes a few seconds before it responds. Do not push
the On/off button again during this period. A second push will initiate a full shutdown.
Table 4-2
Step
Connect the female plug on the Power Cable to the Power Inlet
1
at the rear of the unit.
2
Lock the plug in position with the retaining clasp.
Verify that the Mains Power Circuit Breaker is in OFF position,
3
eventually switch it OFF.
Connect the other end of the Power Cable (with the male plug)
4
to a hospital grade mains power outlet with the proper rated
voltage.
4 - 2
02
EVISION
Connecting Mains Power to the unit
Task
Section 4-2 - General Procedures
V
IVID
Expected Result(s)
.
The retaining clasp prevent the plug from being unplugged during use.
.
The unit is ready for Power ON/Boot Up.
7 / V
7 PRO S
IVID
ERVICE
Clasp OFF
Clasp ON
OFF Position
M
ANUAL
Table of Contents
