Table of Contents
Aftertreatment Device
Aftertreatment Device Condition Display
Aftertreatment Device Display (1) displays the condition of
the aftertreatment device.
This mark indicates that the exhaust temperature
is high during the aftertreatment device
regeneration. It is lit while auto or manual
regeneration is in process.)
f
NOTE:
The auto-regeneration is performed at random times.
The auto-regeneration may start during operation of the
machine; you can continue to operate the machine.
Do not stop the engine during regeneration unless
absolutely necessary.
When the manual regeneration switch is pushed during the
auto-regeneration process, the message "Minimal Exhaust
Restriction. Exhaust Filter Cleaning Not Available." will be
displayed on monitor (2).
Depending on the operating conditions of the machine,
the regeneration may not be completed. In this case,
an aftertreatment device regeneration request will be
displayed on the monitor. Immediately perform manual
regeneration following the procedure.
This mark indicates that the aftertreatment device
regeneration is inhibited. Regeneration will not be
performed while this mark is lit.)
IMPORTANT: Set the aftertreatment device regeneration
to the inhibited position while operating the machine
in an environment with materials that could be
flammable. (Refer to the page 1-57)
OPERATOR'S STATION
1-33
2
MNFB-01-100EN
1
Table of Contents
