Table of Contents
GE H
EALTHCARE
D
GA091568, R
IRECTION
8-5-12
Rear Bumper replacement
8-5-12-1
Preparations
When preparing for the replacement, you must perform the following steps:
ENERGY CONTROL AND POWER LOCKOUT FOR VIVID E9.
WARNING
WARNING
WHEN SERVICING PARTS OF THE SYSTEM WHERE THERE IS EXPOSURE TO
VOLTAGE GREATER THAN 30 VOLTS:
1. FOLLOW LOCK OUT/TAG OUT PROCEDURES.
TAG
&
LOCKOUT
2. TURN OFF THE BREAKER.
Signed
Date
3. UNPLUG THE VIVID E9.
4. MAINTAIN CONTROL OF THE POWER PLUG.
5. WAIT FOR AT LEAST 20 SECONDS FOR CAPACITORS TO DISCHARGE, AS THERE ARE NO TEST POINTS TO
VERIFY ISOLATION. THE AMBER LIGHT ON THE OP PANEL ON/OFF BUTTON WILL TURN OFF.
BEWARE THAT THE MAIN POWER SUPPLY AND BACK END PROCESSOR MAY BE ENERGIZED EVEN IF THE POWER
IS TURNED OFF WHEN THE CORD IS STILL PLUGGED INTO THE AC OUTLET.
1.) Power down the VIVID E9
2.) Disconnect the Mains Power Cable from the wall outlet.
3.) Disconnect all probes and external I/O cabling.
4.) Remove Side Covers.
5.) Remove Rear Cover.
8-5-12-2
Rear Bumper removal procedure
Follow these steps to remove the Rear Bumper:
1.) Remove one screw on each side of the VIVID E9.
Figure 8-60 Left screw placement for Rear Bumper
2.) Remove the Rear Bumper.
8-5-12-3
Rear Bumper installation procedure
Follow these steps to install the Rear Bumper:
1.) Place the Rear Bumper into position
2.) Install the 2 screws to secure the Rear Bumper.
5
EVISION
Chapter 8 - Replacement procedures
VIVID E9 S
M
ERVICE
ANUAL
8 - 59
Table of Contents
Troubleshooting
