Connecting The E2600 Controller-Drive Tray To The Drive Trays; Key Terms; Things To Know - E2600 Controller-Drive Tray; Things To Know - Drive Trays With The E2600 Controller-Drive Tray - Bosch DSA E Series Installation Manual

Iscsi disk arrays
Hide thumbs Also See for DSA E Series:
Table of Contents
E2600 DSA E-Series iSCSI Disk Arrays
8
Connecting the E2600 Controller-Drive Tray to the
Drive Trays
8.1

Key Terms

drive channel
The path for the transfer of data between the controllers and the drives in the storage array.
8.2
Things to Know – E2600 Controller-Drive Tray
NOTICE!
On the E2600 controller-drive tray, each controller has a pair of levers with handles for
removing the controller from the controller-drive tray. One of these handles on each controller
is located next to a host connector. The close spacing between the handle and the host
connector might make it difficult to remove a cable that is attached to the host connector. If
this problem occurs, use a flat-blade screwdriver to push in the release component on the
cable connector.
Figure 8.1 Drive Channel Ports on the E2600 Controller-Drive Tray – Rear View
1
2
NOTICE!
To maintain data access in the event of the failure of a controller, an ESM, or a drive channel,
you must connect a drive tray or a string of drive trays to both drive channels on a redundant
path pair.
8.3
Things to Know – Drive Trays with the E2600 Controller-Drive
Tray
Bosch Security Systems
The E2600 controller-drive tray supports the DE1600 drive tray for expansion.
The maximum number of drive slots in the storage array is 96 (expandable to 192,
including the 12 or 24 drive slots in the controller-drive tray. Exceeding 96 (or 192) drive
slots makes the storage array invalid. The controllers cannot perform operations that
modify the configuration, such as creating new volumes.
Each controller has one dual-ported SAS expansion connector to connect to the drive
trays.
Controller Canister
SAS Expansion Connector
Each DE1600 drive tray can contain a maximum of twelve 8.89-cm (3.5-in.) drives.
The ESMs on the DE1600 drive tray contain two sets of In connectors and one set of Out
connectors.
Installation Manual
Connecting the E2600 Controller-Drive Tray to the Drive Trays | en
53
- | V2 | 2012.09
Table of Contents
loading

This manual is also suitable for:

Dsa e2600

Table of Contents