Character Deactivation Mode; Deactivation Character; Reread Delay - Honeywell Voyager 1250g User Manual
Single-line laser scanner
Hide thumbs
Also See for Voyager 1250g:
- User manual (240 pages) ,
- User manual (246 pages) ,
- Quick start manual (14 pages)
Table of Contents
Character Deactivation Mode
If you have sent a character from the host to trigger the scanner to begin scanning,
you can also send a deactivation character to stop scanning. Scan the On bar code
below to use character deactivation, then use Deactivation Character (following)
to select the character you will send from the host to terminate scanning. Default =
Off.
Deactivation Character
This sets the character used to terminate scanning when using Character Deacti-
vation Mode. On the
the hex value that represents the character you want to use to terminate scanning.
Scan the bar code below, then use the
alphanumeric combination that represents that ASCII character. Scan
ish.
Reread Delay
This sets the time period before the scanner can read the same bar code a second
time. Setting a reread delay protects against accidental rereads of the same bar
code. Longer delays are effective in minimizing accidental rereads. Use shorter
delays in applications where repetitive bar code scanning is required. Default =
Medium.
54
* Off
ASCII Conversion Chart (Code Page 1252)
Short (500 ms)
Programming Chart
Deactivation Character
On
on page 192, find
on page 202 to read the
Save
* Medium (750 ms)
Voyager 1250g User Guide
to fin-
Hide quick links:
Table of Contents
