Reset The Custom Defaults - Honeywell Voyager 1250g User Manual
Single-line laser scanner
Hide thumbs
Also See for Voyager 1250g:
- User manual (240 pages) ,
- User manual (246 pages) ,
- Quick start manual (14 pages)
Table of Contents
command. After scanning the Read Time-Out bar code, set the time-out duration
(from 0-300,000 milliseconds) by scanning digits on the
page 202, then scanning Save. Default = 30,000 ms.
Reset the Custom Defaults
If you want the custom default settings restored to your scanner, scan the Activate
Custom Defaults bar code below. This resets the scanner to the custom default
settings. If there are no custom defaults, it will reset the scanner to the factory
default settings. Any settings that have not been specified through the custom
defaults will be defaulted to the factory default settings.
The charts on the following pages list the factory default settings for each of the
commands (indicated by an asterisk (*) on the programming pages).
Voyager 1250g User Guide
Read Time-Out
Activate Custom Defaults
Programming Chart
on
155
Hide quick links:
Table of Contents
