Table of Contents
(
Remove the nozzle orifice once and make sure
d)
that the O-ring has been installed.
(
Remove the nozzle orifice, and use the four
e)
screws to secure it.
● Use the four screws to secure the nozzle orifice so that
the characters on it face up.
● Tighten the four screws little by little alternately.
(
Reinstall the charge electrode and deflection
f)
electrode.
Press the Ink stream alignment
4
the stream and clogging of the nozzle have been repaired.
● Perform this operation with the tip of the print head inserted into a beaker.
● When the ink stream is way outside the gutter, cleaning of the nozzle orifice may not be sufficient.
Disassemble and clean the nozzle orifice again.
● When the ink stream position has deviated from the center of the gutter, adjust it in accordance
with par. "6.5 Stream alignment".
6-13 ●How to correct ink stream bending and nozzle clogging
Attach to the groove
Characters
Upper
Lower
Start/Continue and confirm that bending of
→
O-ring
Charge electrode
Nozzle orifice
Hide quick links:
Table of Contents
Related Manuals for Hitachi IJ RX2
Related Products for Hitachi IJ RX2
- Hitachi IJ PH
- Hitachi IJ UX
- Hitachi IJ UX2
- Hitachi IPJ-AW250N
- Hitachi Innovate iPJ-AW250NM
- Hitachi IC25N040ATCS04-0 - Travelstar 40GN 40GB UDMA/100 4200RPM 2MB 2.5" IDE Hard Drive
- Hitachi IC25N080ATMR04-0 - 3E034 - Dell 80GB Laptop Hard Drive
- Hitachi IC25N040ATMR04-0 - Travelstar 40GB Laptop Hard Drive 9.5mm 2.5 Inch Notebook HDD