Wiring - Panasonic CZ-RWSU2 Installation Instructions Manual

CZ-RWSL2

Metal Panel

Installing the Operation Panel

1 Remove the 2 screws and remove cover A from the back of the panel. (Fig. A)

2 Fasten the operation panel to the location in the diagram below with the 2 enclosed screws (4 × 10). (Fig. B)

3 Pass the wiring for the display (W2, 6P white connector) through the back of the panel.

Fig. A

Installing the Display

1 Cover B is fi t into Cover A, so spread the points as indicated in fi gure C and remove it.

The tape holding cover B is only to protect it during transport, so remove it and throw it away.

2 Connect the wiring (W2) for the display that is sticking out from the operation panel and fi t the display into the

panel.

Make sure the 6P white connector is fi rmly connected all the way in.

3 Pass the lead wire for the display through the cutout in the panel, and using the hole in the metal panel, fasten it

with the plastic clamp. (Fig. D)

4 Attach cover A.

5 Properly route the lead wire of the operation panel and fasten it with the twist lock. (Fig. B)

6 Install the ceiling panel.

Fig. C

Spread

the power source, it can cause a malfunction, so avoid doing so.

such as by installing a noise fi lter.

For more information about wiring or test runs, refer to Wiring the Receiver and Test Run.

Wiring Diagram

Terminal Strip

for Wiring

Remote

Controls

Connections

1 Connect W1 to the remote control terminal strip on the indoor unit. (Polarity does not matter)

2 Connect the display and the operation panel with W2.

10

Cover A

Cover B

Connect

Pass through cutout

Indoor Unit

Operation Panel

White

Black

Loop extra wiring and fasten

Fig. B

with a twist lock.

Operation Panel

Fig. D

Display

Blue

Yellow

Pink

Red

Gray

Black

Enclosed screws (4 × 10)

Fasten to hole in metal panel

Display