Cz-Rwsl2; Accessories; Installing The Display/Operation Panel - Panasonic CZ-RWSU2 Installation Instructions Manual

No.

1

Operation Panel

2

Display

3

Remote Control

4

Remote Control Holder

Resin Panel

Installing the Operation Panel

1 Remove the 2 screws and remove cover A from the back of the panel. (Fig. A)

2 Fasten the operation panel to the location in the diagram below with the 2 enclosed screws (4 × 10). (Fig. B)

3 Pass the wiring for the display (W2, 6P white connector) through the back of the panel.

Fig. A

Installing the Display

1 Cover B is fi tted inside cover A, so remove the 1 screw and detach it by pressing on it from the front side of the

panel. (Fig. C)

2 Connect the wiring (W2) for the display that is sticking out from the operation panel and fi t the display into the

panel.

Make sure the 6P white connector is fi rmly connected all the way in.

3 Bend the lead wire of the display into shape so it does not come in contact with the louver shaft.

There is a groove in the circled part in diagram 3 that is for passing wire through; press the lead wire into this

groove so there is no slack in it.

4 Attach cover A. When doing so, press it securely into the place indicated by the arrow in Fig D.

5 Shape the lead wire of the operation panel appropriately and fasten it with the enclosed plastic clamp.

6 Install the ceiling panel.

Fig. C

Accessories

Quantity

No.

1

4

Dry-cell Batteries

5

Users Manual

1

6

Truss Self-Tapping Screws

4 × 16

1

7

Pan Head Self-Tapping Screws

4 × 10

1

8

Plastic Clamp L150

Fig. B

Cover A

Display wiring (W2)

Display

Cover B

Connect

Accessories

Enclosed screws

(4 × 10)

Operation Panel

Fig. D

Quantity

2

1

2

EN

4

3

9