Table of Contents
5. With the help of a second person, carefully raise
the Left Upright (70) and the Right Upright (not
shown) to a vertical position.
Remove the knob from the pin. Make sure that
the collar and the spring are on the pin. (Note: If
there are two collars, place one on each side of
the spring.) Then, insert the pin into the Latch
Housing (71), and tighten the knob onto the pin.
See steps 2 and 4. Fully tighten the two
Endcap Screws (79).
6. Slide a Handrail (62) onto the post on the Left
Upright (70). Finger tighten two 1 1/4" Bolts (63)
into the Handrail and the post; do not fully
tighten the Bolts yet.
Attach the other Handrail (62) to the Right
Upright (76) in the same way.
7. Make sure that the Upright Wire (75) is posi-
tioned at the side of the post on the Right
Upright (76) as shown.
Set the Pulse Bar (66) on the Left and Right
Uprights (70, 76). Attach the Pulse Bar with four
Silver Pulse Bar Screws (64) and four Pulse Bar
Star Washers (65). Start all four Silver Pulse
Bar Screws before firmly tightening them.
Firmly tighten the four 1 1/4" Bolts (63).
5
Knob
6
63
62
7
64
65
63
70
8
70
71
Spring
Collar
Pin
Post
63
70
62
76
64
66
63
75
65
76
Table of Contents
