Output Sequence Overview - Honeywell 4600g User Manual
Honeywell commercial/retail/industrial area imager user's guide
Hide thumbs
Also See for 4600g:
- Quick start manual (21 pages) ,
- User manual (248 pages) ,
- Specifications (2 pages)
Table of Contents
Preferred Symbology Default
Scan the barcode below to set all Preferred Symbology entries to their default
values.
Output Sequence Overview
Require Output Sequence
When turned off, the barcode data will be output to the host as the Imager
decodes it. When turned on, all output data must conform to an edited
sequence or the imager will not transmit the output data to the host device.
Note: This selection is unavailable when
enabled.
Output Sequence Editor
This programming selection allows you to program the imager to output data
(when scanning more than one symbol) in whatever order your application
requires, regardless of the order in which the barcodes are scanned. Reading
the Default Sequence symbol programs the imager to the Universal values,
shown below. These are the defaults. Be certain you want to delete or clear all
formats before you read the Default Sequence symbol.
Note: To make Output Sequence Editor selections, you'll need to know the code
I.D., code length, and character match(es) your application requires. Use
the Alphanumeric symbols (inside back cover) to read these options.
You must hold the trigger while reading each barcode in the sequence.
To Add an Output Sequence
1. Scan the Enter Sequence symbol (see
19).
2. Code I.D.
On the
Symbology Chart
to apply the output sequence format. Locate the Hex value for that symbol-
ogy and scan the 2 digit hex value from the Programming Chart (inside back
cover).
3. Length
Specify what length (up to 9999 characters) of data output will be acceptable
for this symbology. Scan the four digit data length from the Programming
Chart. (Note: 50 characters is entered as 0050. 9999 is a universal num-
ber, indicating all lengths.) When calculating the length, you must count any
programmed prefixes, suffixes, or formatted characters as part of the length
(unless using 9999).
4. Character Match Sequences
On the
ASCII Conversion Chart (Code Page
Preferred Symbology Default
on page A-1, find the symbology to which you want
Multiple Symbols
Require Output
1252), page A-4, find the Hex
(page 3-20) is
Sequence, page 3-
3 - 17
- Quick Links:
- Programming the Interface - Plug and...
Hide quick links:
Table of Contents
