3820, 3820i, 4820, 4820i Cordless Imaging Systems Quick Start Guide Aller à www.honeywellaidc.com pour le français. Vai a www.honeywellaidc.com per l'italiano. Gehe zu www.honeywellaidc.com für Deutsch. Ir a www.honeywellaidc.com para español. 日本語 : をご覧ください。 www.honeywellaidc.com 如要到中国 www.honeywellaidc.com(简体) 。 查看繁体版请登陆 www.honeywellaidc.com 한글...
Note: Refer to your user’s guide for information about cleaning your device. For localized language versions of this document, go to www.honeywellaidc.com. Getting Started Turn off the computer’s power before connecting the base, then power up the computer once the base is fully connected. When the base is connected and powered up, put the imager in the base to establish a link.
Page 3
USB Connection Keyboard Wedge Connection...
Serial (RS-232) Connection Reading Techniques The view finder projects an aiming Center beam that should be centered over beam over bar code the bar code. (The 4820/4820i can be positioned in any direction for a good read.) 4820/4820i Hold the imager over the bar code, can read in pull the trigger, and center the any direction...
Note: If the imager beeps 3 times when scanning a bar code, the link has not been established. If the imager beeps once, the link has been established. Standard Product Defaults This bar code resets all standard product default settings. Standard Product Defaults...
Page 6
PC Interface Scan the bar code that describes the PC or interface you are using. USB Keyboard (PC) RS-232 Japan DOS/V USB Japanese Keyboard (PC) AT/PS2 Keyboard Wedge (Default) Emulate External Keyboard...
Keyboard Country Scan the Program Keyboard Country bar code below, then scan the numeric bar code(s) from the back of this sheet, then the Save bar code to program the keyboard for your country. As a general rule, the following characters are not supported by the imager for countries other than the United States: @ | $ # { } [ ] = / ‘...
Open Link Scan the Open Link bar code, then place the imager into the base to establish a link. Placing a different imager into the base establishes a new link and the old imager is unlinked. Open Link Override Locked Imager If you need to replace a broken or lost imager that is linked to a base, scan the Override Locked Imager bar code with a new imager, and place that imager in the base.
Trigger The following bar codes will allow you to use the reader in Manual Trigger mode (need to press the trigger to read) or Presentation mode (the reader is activated when it “sees” a bar code). Manual Trigger (Default) Presentation Mode Streaming Presentation™...
Reread Delay This sets the time period before the imager can read the same bar code a second time. Setting a reread delay protects against accidental rereads of the same bar code. Medium Reread Delay Suffix If you want a carriage return after the bar code, scan the Add CR Suffix bar code.
Add Code ID Prefix to all Symbologies Scan the following bar code if you wish to add a Code ID prefix to all symbologies at once. Add Code ID Prefix to all Symbologies (Temporary) Note: For complete list of Code IDs, see the User’s Guide for your product at our website, www.honeywellaidc.com.
Data Format Editor Instructions The following are abbreviated instructions for entering a data format. For complete instructions refer to your User’s Guide, available at our website, www.honeywellaidc.com. 1. Scan the Enter Data Format symbol. 2. Primary/Alternate Format: scan 0 for Primary Format 3.
For patent information, go to www.honeywellaidc.com/patents. Disclaimer Honeywell International Inc. (“HII”) reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should in all cases consult HII to determine whether any such changes have been made.