IMPORTANT: Your ceiling fan will not General function properly, Your Emerson ceiling fan comes supplied damaged, if used with any wall dimmer with a Fan/Light Wall Control which switch or control other than the consists of a wall control (transmitter) and...
Page 6
1. Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 1). Remove the clevis pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for DOWNROD DOWNROD reinstallation in step 5.
How to Wire WARNING Your Ceiling Fan Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, If you feel that you do not have enough remove wall board until bracket contacts electrical wiring knowledge box. If bracket and/or outlet box are not experience, have your fan installed by a securely attached, the fan could wobble licensed electrician.
Page 10
RECEIVER WHITE WIRE STUD (2) Figure 13 SW101 FAN/LIGHT WALL CONTROL (SUPPLIED) BLACK BLACK (HOT) BLACK LIGHT 120- FAN OFF VOLT WHITE EMERSON ® SUPPLY WHITE WHITE GROUND TWO-CONDUCTOR BLUE WHITE CABLE (WITH GROUND) BLACK GREEN WIRE (GROUND) BLUE FROM HANGER BALL AND...
Page 12
16 LIGHT possible code combinations. The four BLACK FAN OFF EMERSON ® levers (numbered 1, 2, 3, and 4) on the switches are factory-set in the ON (up) position. Change the switch settings as...
NOTE: Retrofit 3-way installations are likely to include two traveler wires LIGHT between the two wall boxes. In new construction, only one traveler wire Is FAN OFF required. EMERSON ® FAN/LIGHT 3-WAY WIRlNG DIAGRAM: WALL WALL NEW CONSTRUCTION CONTROL...
EXISTING WALL CONTROL (see step 4). TRAVELER WIRES LOAD LIGHT LIGHT LIGHT FAN OFF FAN OFF ® EMERSON ® EMERSON FAN/LIGHT WALL CONTROL TRAVELER WIRES LOAD FAN OFF Figure 22 ® EMERSON Operating Your...
Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.
WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER BEFORE TROUBLE SHOOTING YOUR FAN. Trouble Shooting TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not 1. Fuse or circuit breaker 1. Check main and branch start.
If repair of the motor or blades is not practical or possible within a reasonable time and no replacement can be provided, Emerson Electric Co. will refund the actual purchase price of your fan.