Table of Contents
Quick Links
BP7332 CF930
10/27/06
READ AND SAVE THESE INSTRUCTIONS
ATOMICAL
52" Damp Location
Ceiling Fan
Owner's Manual
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This equipment has been certified to comply with the limits for a Class B computing device,
pursuant to FCC Rules. In order to maintain compliance with FCC regulations, shielded
cables must be used with this equipment. Operation with non-approved equipment or
unshielded cables is likely to result in interference to radio and TV reception. The user is
cautioned that changes and modifications made to the equipment without the approval of
manufacturer could void the user's authority to operate this equipment.
This Class B digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulations.
Part No. F40BP73320000
10:05 AM
Page 1
CF930BS00
CF930ORB00
™
CF930WW00
Net Weight:
INSTRUCTION TO THE USER
(if device contains a digital device)
Model No.
18.0
Lbs.
Form No. BP7332
UL Model No.: CF930
Table of Contents
Related Manuals for Emerson CF930BS00
Summary of Contents for Emerson CF930BS00
- Page 1 BP7332 CF930 10/27/06 10:05 AM Page 1 READ AND SAVE THESE INSTRUCTIONS Model No. CF930BS00 CF930ORB00 ATOMICAL ™ CF930WW00 52” Damp Location Ceiling Fan 18.0 Net Weight: Lbs. Owner's Manual INSTRUCTION TO THE USER (if device contains a digital device) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
-
Page 2: Safety Instructions
WARNING: This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage. -
Page 3: Unpacking Instructions
One loose parts bag containing: Emerson Electric Co. Substitution of parts or accessories not designated for 1. One clevis pin use with this product by Emerson Electric 2. One hairpin clip Co. could result in personal injury or 3. Three 12 ga. wire connectors property damage. - Page 4 ASSEMBLY I. LOWER GLASS J. FAN/LIGHT WALL CONTROL K. LOOSE PARTS BAG LIGHT FAN OFF EMERSON ® NOTE: Place the parts from the loose PROTECTIVE parts bags in a small container to keep PLASTIC BAG them from being lost. 2. Remove and discard the two cardboard shipping retainers securing the motor hub in the motor housing assembly.
-
Page 5: Electrical Requirements
IMPORTANT: Your ceiling fan will not General function properly, Your Emerson ceiling fan comes supplied damaged, if used with any wall dimmer with a Fan/Light Wall Control which switch or control other than the consists of a wall control (transmitter) and... - Page 6 BP7332 CF930 10/27/06 10:05 AM Page 6 1. Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 1). Remove the clevis pin from the downrod, then remove the hanger ball.
- Page 7 BP7332 CF930 10/27/06 10:05 AM Page 7 5. Reinstall the hanger ball (Figure 4) on the PARTIALLY ASSEMBLED downrod as follows. Route the motor leads through the downrod. Position the pin through the two holes in the downrod and align the ball so the pin is captured in SOLID the groove in the top of the hanger ball.
-
Page 8: How To Hang Your Ceiling Fan
BP7332 CF930 10/27/06 10:05 AM Page 8 NOTE: Make sure wires are not pinched How to Hang between fan motor assembly and lower Your Ceiling Fan housing. 10. Connect the black wire of the light kit WARNING assembly to the blue wire of the fan motor assembly using one wire The fan must be hung with at least 7' of connector (supplied). -
Page 9: How To Wire Your Ceiling Fan
BP7332 CF930 10/27/06 10:05 AM Page 9 How to Wire WARNING Your Ceiling Fan Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, If you feel that you do not have enough remove wall board until bracket contacts electrical wiring knowledge... - Page 10 RECEIVER WHITE WIRE STUD (2) Figure 13 SW101 FAN/LIGHT WALL CONTROL (SUPPLIED) BLACK BLACK (HOT) BLACK LIGHT 120- FAN OFF VOLT WHITE EMERSON ® SUPPLY WHITE WHITE GROUND TWO-CONDUCTOR BLUE WHITE CABLE (WITH GROUND) BLACK GREEN WIRE (GROUND) BLUE FROM HANGER BALL AND...
- Page 11 BP7332 CF930 10/27/06 10:05 AM Page 11 3. Push the wires and connectors up into 7. Screw in two 60-watt (maximum) the outlet box while inserting the candelabra base bulbs (not included) in receiver fully into the hanger bracket. the light kit assembly sockets (Figure Position the antenna wire on top of the 16).
- Page 12 16 LIGHT possible code combinations. The four FAN OFF BLACK EMERSON ® levers (numbered 1, 2, 3, and 4) on the switches are factory-set in the ON (up) position. Change the switch settings as...
- Page 13 NOTE: Retrofit 3-way installations are likely to include two traveler wires LIGHT between the two wall boxes. In new construction, only one traveler wire Is FAN OFF required. ® EMERSON FAN/LIGHT 3-WAY WIRlNG DIAGRAM: WALL WALL NEW CONSTRUCTION CONTROL Figure 20...
-
Page 14: Operating Your Ceiling Fan
EXISTING WALL CONTROL (see step 4). TRAVELER WIRES LOAD LIGHT LIGHT LIGHT FAN OFF FAN OFF ® EMERSON ® EMERSON FAN/LIGHT WALL CONTROL TRAVELER WIRES LOAD FAN OFF Figure 22 ® EMERSON Operating Your... -
Page 15: Maintenance
Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage. -
Page 16: How To Order Repair Parts
10/27/06 10:05 AM Page 16 Repair Parts LIGHT FAN OFF EMERSON ® Before discarding packaging material, be certain all parts have been removed. HOW TO ORDER REPAIR PARTS WHEN ORDERING REPAIR PARTS, ALWAYS GIVE THE FOLLOWING INFORMATION: • PART NUMBER •... - Page 17 BP7332 CF930 10/27/06 10:05 AM Page 17 Repair Parts Listing Part Numbers Model No. Model No. Model No. Description CF930BS00 CF930ORB00 CF930WW00 Hanger Pack, Consisting of: 761655-17 761655-32 761655 Hanger Bracket Assembly (1) — — — Hanger Ball (1) —...
-
Page 18: Troubleshooting
BP7332 CF930 10/27/06 10:05 AM Page 18 WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER BEFORE TROUBLE SHOOTING YOUR FAN. Trouble Shooting TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not 1. Fuse or circuit breaker 1. -
Page 19: Limited Warranty
If repair of the motor or blades is not practical or possible within a reasonable time and no replacement can be provided, Emerson Electric Co. will refund the actual purchase price of your fan. - Page 20 BP7332 CF930 10/27/06 10:05 AM Page 20 Air Comfort Products DIVISION OF EMERSON ELECTRIC CO. 8100 W. Florissant ¥ St. Louis, MO 63136 Part No. F40BP73320000 Printed in China 11/06 Form No. BP7332...