How to Put Your Ceiling Fan Together 1. Remove the hanger ball by loosening the setscrew 5. Make sure the grommet is properly installed in the in the hanger ball until the ball falls freely down the coupling cover, then slide the coupling cover on the downrod (Figure 1).
Page 5
12. Engage the connector of the switch housing WARNING assembly with the motor connector (Figure 7). The two connectors are keyed and color-coded To reduce the risk of personal injury, do not bend the and must be mated correctly (color-to-color) blade flange when installing the blade flanges, before they can be engaged.
Electrical Requirements WARNING Your new ceiling fan will require a grounded electrical To reduce the risk of fire, electric shock, or personal supply line of 120 volts AC, 60 Hz, 15 amp circuit. injury, mount fan to outlet box marked “Acceptable for Fan Support”, and use screws supplied with outlet box.
(Figure 12.) fits snugly against the ceiling and the hole in the NOTE: If you are using an Emerson Light Fixture ceiling cover is clear of the downrod. Your fan is with your fan, see Light Fixture Owner’s Manual now wired to be turned on and off from the fan for wiring.
The fan blades will turn in install the fan 8 - 9 feet above the floor for optimal air- the opposite direction and reverse the airflow. flow. Consult your Emerson Retailer for optional mounting accessories. Your fan model is equipped with a 4-position, 3-speed pull chain switch.
WARNING Emerson Electric Co. Substitution of parts or acces- sories not designated for use with this product by The use of any other control not specifically Emerson Electric Co.