Table of Contents
32/70
Assembly
Bosch Rexroth AG, General Operating Instructions HYDROTRAC GFT 8000 series 40, RE 79022-01-B/04.2020
6
When installing the axial-piston motor, ensure careful sealing (O-ring). Ensure
that the O-ring is installed correctly in the corresponding O-ring groove of the
axial-piston motor.
7
Attach the axial piston motor with the motor fastening screws 3. Tighten the
motor fastening screws with a torque wrench. Take the tightening torques from
the spare parts drawing in appendix D "Technical data / Drawings" of the
material number-specific operating instructions.
8
Remove all means of attachment, transport and lifting equipment.
9
Connect all power units and mounting parts required for operation of the
planetary gearbox. For this, observe the instructions in chapter 7 "Assembly".
7.5.3 Connecting the planetary gearbox's axial-piston motor to the hydraulic
system
The machine or vehicle manufacturer is responsible for laying the lines. The axial-
piston motor or the static multiple-disk parking brake (parking brake) has to be
connected to the hydraulic system according to the machine or vehicle
manufacturer's hydraulic diagram.
Failure or damage to the planetary gearbox!
Operation of the axial-piston motor without reading the general operating
instructions of the axial-piston motor first or observing the hydraulic circuit
diagram of the machine or vehicle manufacturer may cause damage to the axial-
piston motor/planetary gearbox/machine or vehicle!
For installation of the axial-piston motor, please refer to the general operating
instructions in chapter C "Mounting parts" of the material number-specific
operating instructions.
Observe the hydraulic circuit diagram of the machine or vehicle manufacturer.
CAUTION
Table of Contents
