Table of Contents
7.5 Assembling the HYDROTRAC GFT 8000
The required, proper assembly sequence depends on the machine or chassis frame
design and may therefore differ from the assembly sequence described in these
operating instructions.
7.5.1 Preparing assembly
1
Check if the scope of supply is complete and shows transport damages. Refer
Procedure
to your material number-specific operating instructions for the complete scope
of supply.
2
Compare the material number and the type designation on the nameplate with
the details in the order confirmation or on the delivery note. If the material
number of the planetary gearbox does not match the order confirmation or the
delivery note, please contact the Rexroth Service.
Compare the connecting dimensions of planetary gearbox and chassis or
3
equipment frame.
4
Compare the connecting dimensions of the planetary gearbox with the rim.
The mounting order depends on the machine, the vehicle or the chassis or
equipment frame design. Refer to the instructions in chapter 7.2 "Installation
conditions". In addition, observe the assembly instructions of the machine or
vehicle manufacturer.
The dimensioned drawing contains the dimensions of all connections of the
HYDROTRAC GFT 8000 planetary gearbox. Also observe the instructions of the
manufacturers of the mounting parts in appendix C "Mounting parts" in the
material number-specific operating instructions.
Remove the preservative from the outside flange surfaces with a suitable
5
organic solvent (e.g. HAKUTEX 74) or an alkaline detergent (e.g. HAKUPUR
236). Wear suitable protective gloves and protective goggles when cleaning the
planetary gearbox and observe the manufacturer's safety notes when handling
preservative or solvents. These data sheets are not included within Rexroth's
scope of supply.
Damages to the seals!
Aggressive detergents or solvents can damage the seals of the planetary gearbox
and can cause the seals to age faster!
When removing the preserving agent make sure that no aggressive detergents
or solvents enter the seal areas. This applies in particular to the area of the
output seals.
RE 79022-01-B/04.2020, General Operating Instructions HYDROTRAC GFT 8000 series 40, Bosch Rexroth AG
NOTE
Assembly
29/70
Table of Contents
