Table of Contents
8 | OPERATION
Room temperature sensor selection
Press the FOLLOW ME button to select whether the room
temperature is detected at the indoor unit or the wired controller.
Press the FOLLOW ME button to select whether the room
temperature is detected at the indoor unit or the wired controller.
Indoor
Unit
When the Follow me function indication
temperature is detected at the wired controller.
Child lock function
Press the button "+" and "-" simultaneously for 3 seconds to activate
the child lock function and lock all buttons on the wired controller.
Press the buttons again for 3 seconds to deactivate the child lock
function.
When the child lock function is activated, the
Keypad tone setting
Press the button "BACK" and "COPY" simultaneously for 3 seconds
to close the keypad tone.
Press the buttons again for 3 seconds to open the keypad tone.
°C & °F scale selection (on some models)
Press and hold
and
buttons together for 3 seconds will
alternate the temperature display between the °C & °F scale.
6720872735 (2017/04)
Faceplate function (on some models)
The F2 mark appears when
the aceplate is adjusted.
2. Press the button "+" and "-" to control the lift and drop of
the faceplate.
Pressing the "+" button can stop the faceplate, while it is
dropping.
Pressing the "-" button can stop the faceplate, while it is lifting.
Left-Right swing (on some models)
appears, the room
Press the
Press it again to stop.
When the Left-Right swing function is activated, the
appears. (Not applicable to all the models)
Up-Down airflow direction and swing
(on some models)
mark appears.
•
Use
1. Press the button every time, the louvre swings 6 degrees.
2. Press and hold the button for 2 seconds, it turns into up-
•
The operation can refer to the following instructions for the unit
with four Up-Down louvres can be operated individually.
1. Press the
2. Pressing the button "+" or "-" can select the movementof four
3. And then use
1. When the unit is off, press the MODE button
long
to
activate
The mark
will flash.
button to start Left-Right swing function.
button to adjust the Up-down airflow direction.
down swing mode, press ti again to stop.
When the Up-Down swing function is activated, the
mark appears. (Not applicable to all the models)
button to activate the Up-Down adjusting
louvre function.
The
mark will flash. (Not applicable to all the models)
louvres. Each time you push the button, the wire controller
select in a sequence that goes from: (the icon
the four louvres move at the same time.)
button to adjust the Up-Down airflow
direction of the selected louver.
WIRED CONTROLLER OF AIR CONDITIONER
the
faceplate
function.
mark
means
Table of Contents
