(Original instructions) ENGLISH BEPW1600LTH, BEPW1750TH, BEPW1800TTH Maximum Input Pressure PRESSURE WASHER Repulsive Force of the Gun to the Maximum Pressure Technical data Motor Protection IPX5 Inlet Water Cold clear BEPW1600LTH Water Power 1400 Intended use Rated Flow Rate L/min This pressure washer is intended for household use for...
Page 8
ENGLISH (Original instructions) The electric supply connection shall be made by a 13 . Never tie knots or kink the high pressure hose as qualified electrician and comply with IEC 60364-1. It is damage could result. Inspect the high‑pressure recommended that the electric supply to this machine hose regularly.
(Original instructions) ENGLISH WARNING: Depending on the application, WARNING: High pressure jets can be dangerous shielded nozzles can be used for high pressure if subject to misuse. The jet must not be directed cleaning, which will reduce the emission of at persons, live electrical equipment or the hydrous aerosols dramatically.
Page 10
Attaching Handle (Fig. A) Spray Fan to Pencil Jet Nozzle BEPW1600LTH, BEPW1750TH Adjusting Fan Pattern (Fig. E1) Press the handle (18) onto the pressure washer unit (16) and The angle of spray coming out of the spray wand may be secure with the screws supplied.
(Original instructions) ENGLISH Attaching Soap Bottle (Fig. J4) high pressure hose to the pressure washer and spray handle, please refer to Attaching High Pressure Hose To connect the soap bottle ( 11 ) to the spray handle ( 4 ), under Assembly.
ENGLISH (Original instructions) Plug the pressure washer unit into a power source. to Attaching Soap Bottle under Assembly.Attaching Soap Actuate the pressure washer by rotating the ON/OFF Bottle under Assembly. dial to the ON position. The use of detergents can dramatically reduce cleaning time Actuate the trigger of the spray handle to start clean- and assist in the removal of difficult stains.
Page 13
(Original instructions) ENGLISH Notes Note: the turbo or pen to fan nozzles can be sotored on the wand. BLACK+DECKER’s policy is one of continuous Power cord can be stored coiled up and secured with the improvement to our products and, as such, we reserve cord retaining hooks ( 21 ) as shown in Fig.
ENGLISH (Original instructions) Troubleshooting Warning! Risk of Unsafe Operation. Before servicing unit unplug or disconnect electrical supply, turn water supply off, discharge residual pressure, and engage spray handle lock-off. PROBLEM CAUSE CORRECTION Motor does not start. Unit not plugged in. Plug in power cord.
Page 15
(Original instructions) ENGLISH PROBLEM CAUSE CORRECTION No detergent. Detergent container is empty. Add more detergent. Detergent bottle or suction tube Check connections. not properly connected. Detergent is too thick. Use detergent recommended for use in pressure wash- ers only. Filter on detergent suction tube Run warm water through filter to remove debris.