Section 3: Prerequisites For Installation; Inventory; Environmental Specifications; Software Downloads - Honeywell SILENT KNIGHT 6700 Manual

This section of the Manual is intended to help you plan your tasks to facilitate a smooth installation. Please read this section thoroughly,

especially if you are installing a 6700 panel for the first time.

When the 6700 shipment is received, check that all the parts have been included in the shipment. The shipment consists of one of each of the

following:

•

main circuit board with the display

•

backbox with door

•

plastic bag containing two keys, screws, cables, and ten 4.7K ohm end-of-line resistors

•

manual

It is important to protect the 6700 control panel from water. To prevent water damage, the following precautions should be FOLLOWED

when you install the units:

•

Intended for indoor use in dry locations only.

•

Do not mount the panel directly on exterior walls, especially masonry walls (condensation).

•

Do not mount the panel directly on exterior walls below grade (condensation).

•

Protect the panel from plumbing leaks.

•

Protect the panel from splash caused by Sprinkler System inspection ports.

•

Do not mount the panel in areas with humidity-generating equipment (such as dryers, production machinery).

When you select a location to mount the 6700 control panel, the unit should be mounted where it will NOT be exposed to temperatures out-

side the range of 32°F-120°F (0°C-49°C) or humidity outside the range of 10%-93% at 86°F (30°C) non-condensing.

In order to supply the latest features and functionality in fire alarm and life safety technology to our customers, we make frequent upgrades

to the embedded software in our products. To ensure that you install and program the latest features, we strongly recommend that you down-

load the most current version of software for each product prior to commissioning any System. Contact Technical Support with any ques-

tions about software and the appropriate version for a specific application. The HFSS Honeywell Fire Software Suite is available at

www.silentknight.com.

Table 3.1 lists the terminal block on the 6700 as well as a description of each individual terminal and their respective electrical rating. For the

location of the terminals, refer to Figure 4.3. See also Section 4 for installation information.

Terminal No.

Group

Terminal Block 3 TELCO 1

PHONE 1

TELCO 2

PHONE 2

Terminal Block 2 RELAY 1

RELAY 2

TROUBLE

SLC IN

SLC OUT

SLC PROG

6700 Manual — P/N LS10148-001SK-E:F 8/29/2022

Label

Individual

RING

Phone Line 1 Telco Ring

TIP

Phone Line 1 Telco Tip

RING

Phone Line 1 Phone Ring

TIP

Phone Line 1 Phone Tip

RING

Phone Line 2 Telco Ring

TIP

Phone Line 2 Telco Tip

RING

Phone Line 2 Phone Ring

TIP

Phone Line 2 Phone Tip

NO

Normally open relay contact

COM

Common terminal

NC

Normally closed relay contact

NO

Normally open relay contact

COM

Common terminal

NC

Normally closed relay contact

NO

Normally open relay contact

COM

Common terminal

NC

Normally closed relay contact

–

Used for Class A installations

+

SLC terminals

–

+

–

Used for programming SLC Detectors

+

Table 3.1 Terminal Descriptions and Electrical Specifications

Description

Rating

Voltage

Current

27.4 VDC

2.5 A, resistive

27.4 VDC

2.5 A, resistive

27.4 VDC

2.5 A, resistive

32 VDC

100 mA

32 VDC

100 mA

32 VDC

100 mA

15