Table of Contents
Table 5-18 Inactive/Cold Addition Procedure of the SPARC M12-2S (continue d)
Work
Order
7
8
9
10
11
12
13
*1 Connect cables by following the workflow of the addfru command.
5.5
System-Stopped/Hot Addition
Workflows
This section describes the workflows for system-stopped/hot addition of FRUs to the
SPARC M12-2/M12-2S.
Before performing addition work, be sure to check the notes on maintenance work in
the Fujitsu SPARC M12 Product Notes of the XCP version used.
Each of the following sections puts together the order of work and the tasks for each
FRU into a table. For details on each task, see the reference shown in the table.
The following FRUs are subject to system-stopped/hot addition:
PCIe card
■
HDD/SSD
■
PCI expansion unit
■
176
Fujitsu SPARC M12-2/M12-2S Service Manual ･ January 2023
Task
Confirming that there is no problem with
the added SPARC M12-2S
Configuring memory mirroring if
duplicating memory
Adding the added SPARC M12-2S to the
PPAR configuration list for the physical
partition that is the incorporation
destination
Assigning the SPARC M12-2S (system
board) to the physical partition
Switching the mode switch on the OPNL
to Locked
Powering on the physical partition of the
added SPARC M12-2S
Assigning the resources of the added
SPARC M12-2S to logical domains
Reference
"10.5.3 Checking the FRU Status After
Maintenance"
"7.6 Configuring Memory Mirroring" in
the Fujitsu SPARC M12-2S Installation
Guide
"7.7 Creating a PPAR Configuration
List" in the Fujitsu SPARC M12-2S
Installation Guide
"7.8.1 Assigning a Physical System
Board (PSB) to a Physical Partition
(PPAR)" in the Fujitsu SPARC M12-2S
Installation Guide
"2.3.2 OPNL Control
Function"
"10.9.1 Starting the System With an
XSCF
Command"
"3.2 Operations and Commands Related
to Logical Domain Configurations" in the
Fujitsu SPARC M12 and Fujitsu
M10/SPARC M10 Domain Configuration
Guide
Table of Contents
