Table of Contents
SYSTEM DESCRIPTION AND INSTALLATION MANUAL
(2) Reinstall the combiner.
(a) Attach the combiner using two screws.
(b) Remove the protective covers from the connectors and install the aircraft
connectors on the combiner.
(c) Reapply power to the HSU and its interfacing equipment.
(3) Remove the splitter.
(a) Remove power from the HSU. Circuit breakers for the HSU are typically located
on the flight deck.
(b) Locate the splitter.
(c) Disconnect the aircraft connectors from the splitter and place protective covers
on the connectors.
(d) Remove the two screws holding the splitter in position.
(4) Reinstall the splitter.
(a) Attach the splitter using two screws.
(b) Remove the protective covers from the connectors and install the aircraft
connectors on the splitter.
(c) Reapply power to the HSU and its interfacing equipment.
B. Adjustment Procedures
(1) Not applicable.
C. Repair Procedures
(1) Not applicable.
D. Return to Service Procedures
(1) Refer to test procedures in the INSTALLATION CHECK section of this manual.
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.
HS--700 High Speed Data System
23- -20- -33
Page 7--4
30 Aug 2002
Table of Contents
