Table of Contents
1–6
Overview
Required Tools and Equipment
Overview of Setting Up the
Module
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
The tools and equipment required, depend on if you are using a
1203-GD1 module, 1203-GK1 module, or 1336-GM1 board.
1203-GD1 or 1203-GK1 Module
To install and configure a 1203-GD1 module or 1203-GK1 module,
you need the following:
•
Remote I/O communications module (1203-GD1 or 1203-GK1).
•
35 x 7.5 mm DIN rail.
•
Termination resistor(s).
•
Power source.
•
1/8" flathead screwdriver.
•
Appropriate cables for SCANport and Remote I/O connections.
Refer to Chapter 3.
•
Software such as RSLogix5, RSLogix500, or RSLogix5000 for
programming the controller.
1336-GM1 Board
To install and configure a 1336-GM1 board, you need the following:
•
Remote I/O communications board (1336-GM1).
•
A kit that includes one grounding wrist strap, four Phillips
mounting screws, four stand-off nylon headers, one 3-pin
connector, and one snap-in comm housing with mounting
instructions (supplied with board).
•
#1 Phillips screwdriver.
•
Appropriate cable for the Remote I/O connection. Refer to
Chapter 3.
•
Software such as RSLogix5, RSLogix500, or RSLogix5000 for
programming the controller.
To set up the Remote I/O communications module, you must perform
the following tasks:
1. Read the safety precautions in this manual.
2. Configure the module using the DIP switches. Refer to Chapter 2.
3. Install the module or mount the board. Refer to Chapter 3.
4. Create a ladder logic program to control the SCANport product
(Chapter 4) or send messages to it (Chapter 5).
Hide quick links:
Table of Contents
