Table of Contents
Item #
7
8
9
10
11
12
13
You will need:
•
Screw driver, #2 Phillips
•
Screw driver, Hex 1/8"
•
Wrench, 11/32"
1. The two holes at the top of the mounting panel are for the collars that will enable the panel to slide down into the
extrusions. Assemble a collar by placing the small end of the collar against the back of the mounting panel.
2. Insert the screw through a washer and the hole in the panel, then into the collar. Tighten the screw all the way.
Repeat with the other collar.
3. The eight holes in the middle of the mounting panel are for the power supply brackets. Mount a power supply
bracket to the panel by lining up the holes. Refer to the figure below for the correct positioning of the bracket.
4. Insert a screw through a washer and a hole in the bracket and the panel. Tighten with a nut.
5. Repeat for the other holes in the bracket.
6. Repeat the last three steps for the remaining brackets
Charger Wall Mount, Multiple Chargers: Fastening the Collars to a Charger
Parts List:
Item #
14
Quantity
1
2
2
2
8
8
8
Figure 163: Mounting the Power Supply Bracket
Quantity
16
Description
Power supply mounting panel
Collar with nut
Washer, #4, flat, type B regular
Screw #4-40x.625, Phillips pan head
Washer, #8, flat, type B regular
Screw #8-32x.5, Phillips pan head
Nut, #8-32 hex machine screw
Description
Collar (611065)
| Chargers | 231
Hide quick links:
Table of Contents
Troubleshooting
