Table of Contents
Rain/dust: IP67
Battery Notifications
Battery warnings for a Talkman battery occur at the following levels:
•
First warning = 3,45 mV
•
Critical warning = 3,350 mV
Charging an A500 or T5 Battery in a Device
1. Remove the device from the belt clip.
2. Disconnect any other peripherals.
3. Insert the device into an open slot on the charger, pressing down and then back until the device clicks into place.
4. After the device has been placed into the charger, make sure that the LED indicator on the device turns on and
begins to blink green.
a) If the LED does not turn on after 30 seconds, remove the device from the charger slot and then place it into the
slot again.
b) If the LED indicator still does not turn on, try another charger slot.
CAUTION: Do not attempt to place the device into the charger unless you have first disconnected the
headset and any other peripheral devices. Do not remove the battery from the device when placing a device
into a charger.
Charging an A500 or T5-Series Battery
1. Remove the battery from the Talkman device.
2. Hold the battery with its contacts to the bottom and the Vocollect label facing you.
3. Place the battery into an open battery slot on the top level of the charger.
When the battery is placed into the charger properly, the left LED indicator for the slot into which the battery was
placed turns red.
Note: The upper set of LED indicators apply to the charger's battery slots and the lower indicators apply
to the devices' slots.
Removing an A500, T2-Series or T5-Series Device From a Charger
The device is ready to use when the LED indicator on the device is blinking green. If the LED is blinking red, the
device is not ready to be used.
Important: If a device continuously displays a solid red light, contact your system administrator.
1. Make sure that the device is ready to use.
2. Pull up on the device to remove it from the device charger.
Figure 60: Inserting a Battery Into the Charger
| Talkman T5 Series | 110
Hide quick links:
Table of Contents
Troubleshooting
