Siemens SINUMERIK 840D Programming Manual page 241
Cycles
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Diagnostics manual (714 pages) ,
- Operating turning (713 pages)
Table of Contents
3
12.97
11.02
The CYCLE800 start-up process is supported by
the following menu displays:
Start-up of kinematic chain
A swivel data record must be created for each swivel head, swivel
table or each swivel head/table combination.
Swivel data records can be declared in several channels.
The number of swivel data records is limited by the following
machine data:
• MD 18088: MM_NUM_TOOL_CARRIER or
• MD: NUM_CHANNELS (Number of channels option)
• MD 28085: MM_LINK_TOA_UNIT
The swivel data record is assigned to the tool data by parameters
$TC_CARR1[n] to $TC_CARR40[n].
The meaning of the parameters in the "Kinematics" screen form is
as follows:
Name: Swivel data record $TC_CARR34[n]
n à No. of swivel data record
If more than one swivel data record is declared in each NC
channel, then a name is assigned to each record. No name
need be specified if the swivel-mounted toolholder is not
exchangeable (i.e. one swivel data record per channel). The
program is advanced to the next swivel data record and the next
channel via soft keys (channel +/- swivel data record +/-).
Only characters valid for NC programming must appear in
the name!
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
3.16 Swiveling – CYCLE800 (SW 6.2 and higher)
3
Milling Cycles
3-241
Hide quick links:
Table of Contents
