Transfer Pocket Edge Contour - Cycle74 - Siemens SINUMERIK 840D Programming Manual
Cycles
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Diagnostics manual (714 pages) ,
- Operating turning (713 pages)
Table of Contents
3
12.97
08.99
3.15 Pocket milling with islands – CYCLE73, CYCLE74, CYCLE75
3.15.1 Transfer pocket edge contour – CYCLE74
Pocket milling with islands is an option and requires
SW 5.2 in both the NCK and MMC 103.
Programming
CYCLE74 (_KNAME, _LSANF, _LSEND)
Parameters
string
_KNAME
string
_LSANF
string
_LSEND
Function
Cycle CYCLE74 transfers the pocket edge contour to
pocket milling cycle CYCLE73. This is done by creating
a temporary internal file in the standard cycles directory
and storing the transferred parameter values in it.
If a file of this type already exists, it is deleted and set
up again.
For this reason, a program sequence for milling pockets
with islands must always begin with a call for CYCLE74.
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
Name of contour subroutine of pocket edge contour
Block number/label identifying start of contour definition
Block number/label identifying end of contour definition
3
Milling Cycles
3-199
Hide quick links:
Table of Contents
