Siemens Sinamics G120 Function Manual page 326
Safety integrated
Hide thumbs
Also See for Sinamics G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Operation
6.14 List of alarms and faults
Signal
Cause
Complete information on the messages is available in the List Manual.
C01711
Defect in a monitoring channel
(alarm)
1)
Fault value r2124 provides more de‐
tailed information.
326
Remedy
The complete list of the r2124 fault values is provided in the List Man‐
ual.
0 ... 2: Fault in data cross-check between processor 1 and processor 2.
Remedy: Please refer to the List Manual.
3: Difference of the position actual value (r9713) between the two
monitoring channels is greater than the tolerance in p9542.
Setting encoderless actual value sensing (Page 151)
4 ... 43: Fault in data cross-check between processor 1 and process‐
or 2. Remedy: Please refer to the List Manual.
44 ... 57: The tolerance value for the monitoring function differs be‐
tween the two monitoring channels.
Setting encoderless actual value sensing (Page 151)
58 ... 999: Fault in data cross-check between processor 1 and pro‐
cessor 2. Remedy: Please refer to the List Manual.
1000: Check (watchdog) timer has expired.
● Too many signal changes at the F-DI
Remedy:
● Check the F-DI wiring (contact problems).
1001: Initialization error of the check timer.
● Remedy: Switch off the power supply voltage of the inverter and
switch on again.
● Upgrade inverter firmware
1005: Pulses already canceled for test stop selection.
1011: Acceptance test status between the monitoring channels differ.
● Diagnostics in the List Manual under r9571.
1020: Cyclic communication failure between the monitoring channels.
● Remedy: Switch off the power supply voltage of the inverter and
switch on again.
● Replace the Control Unit or the inverter.
1041: Current value too low for encoderless actual value acquisition.
● Reduce the minimum current (p9588).
Safety Integrated - SINAMICS G110M, G120, G120C, G120D and SIMATIC ET 200pro FC-2
Function Manual, 01/2017, FW V4.7 SP6, A5E34261271B AD
- Quick Links:
- Basic Functions and Extended Functions
Hide quick links:
Table of Contents
