Table of Contents
Set up the Module
Configure the Module in a GuardLogix Controller
System
Topic
Set up the Module
Add and Configure the Ethernet Bridge
Add and Configure the 1734 Ethernet Adapter
Add and Configure Safety Digital Input Modules
Add and Configure Safety Digital Output Modules
Add and Configure Safety Analog Input Modules
Values and States of Tags
Configure Safety Connections
Configuration Ownership
Save and Download the Module Configuration
When using a GuardLogix® controller on an EtherNet/IP network, configure the
POINT Guard I/O™ modules by using the Logix Designer application.
You must configure each point that is used as a safety input or output. By
IMPORTANT
default, all safety input and output points are disabled.
If you need an Add-on Profile, visit the My Support website at
TIP
http://support.rockwellautomation.com/ControlFLASH/LogixProfiler.asp.
At the bottom of each dialog box, click Help for information about how to
complete entries in that dialog box. At the bottom of warning dialog boxes, click
Help for information about that specific error.
When first setting up your POINT Guard I/O modules on an EtherNet/IP
network, perform the following steps.
1.
Add and Configure the Ethernet
2.
Add and Configure the 1734 Ethernet
3.
Add and Configure Safety Digital Input
4.
Add and Configure Safety Digital Output
5.
Add and Configure Safety Analog Input
Rockwell Automation Publication 1734-UM013N-EN-P - September 2017
Page
79
80
80
84
93
98
107
109
110
111
Bridge.
Adapter.
Modules.
Modules.
Modules.
5
Chapter
79
Hide quick links:
Table of Contents
