Service Conditions - NEC UNIVERGE SV8300 System Maintenance Manual
Ip pbx
Hide thumbs
Also See for UNIVERGE SV8300:
- Command manual (804 pages) ,
- Pc programming manual (232 pages) ,
- Manual (54 pages)
Table of Contents
Service Conditions
(1)
General conditions
• Terminals/blades and available firmware versions that enable to collect fault logs/call logs are as
follows.
Terminals/Blades
term
Terminals D
85 (Series i) (IP Adapter Type)
term
D
85 (Series i) (IP Bundled Type)
term
D
IP INASET (ITR-240G-1)
Soft Phone (D
Blades
VoIPDB
NOTE:
Fault information store/display is not available for the following D
Type). But it will be available when the new firmware is installed.
- ITR-8D-2 (BK/WH) TEL (Available when firmware of ITR-8D-3 (BK/WH) TEL is installed)
- ITR-16D-2 (BK/WH) TEL (Available when firmware of ITR-16D-3 (BK/WH) TEL is installed)
- ITR-8D-2A (BK/WH) TEL (Available when firmware of ITR-8D-3A (BK/WH) TEL is installed)
- ITR-16D-2A (BK/WH) TEL (Available when firmware of ITR-16D-3A (BK/WH) TEL is in-
stalled)
- ITR-8D-2U (BK/WH) TEL (Available when firmware of ITR-8D-3 (BK/WH) TEL is installed)
- ITR-16D-2U (BK/WH) TEL (Available when firmware of ITR-16D-3 (BK/WH) TEL is in-
stalled)
• Collected fault logs and call logs can be output to a PC via the RS port (RS-232C) of the CPU
blade. To output the fault logs and call logs, communication software (Hyper Terminal, etc.) must
be installed in the PC (PCPro cannot be used while using the communication software).
NOTE
term
SP30 only)
Chapter 1 MAINTENANCE SERVICES
Firmware Version
Ver. 2.80 or later
Ver. 2.80 or later
E0 2.80 or later
F Ver. 7.3.0.0 or later
1-34
VoIP LOG COLLECTION
Available: ×
Fault Log
Call Log
Collection
Collection
×
×
×
×
×
×
×
×
×
×
term
85 (Series i) (IP Bundled
NWA-033627-001 Rev.4.0
95ch1001.fm
APRIL/16/2010
Chapters
Table of Contents
Troubleshooting
