Table of Contents
(5) Install the control box cover as shown below.
(Align the cover with the upper and lower right corners as indicated by the triangular
symbols on the figure.
Insert the clasps on the cover into both sides at the bottom of the two dotted
circles.)
• When installing the control box cover, make sure that the cables are not caught as
shown in the detail view.
(6) Install one screw.
(7) Screw the earth wire of wired remote controller as shown
in the figure. (AUSTRALIA model only).
Cover
(5)
Installing communication box
13.3.
13.3.1. Removing intake grille
( See "9.1. Front panel removal" )
13.3.2. Removing control box
(1) Remove the screws (x4). (Use the same screws when installing.)
(2) Pull the control box cover towards you and remove.
(1)
(1)
(1)
(1)
(3) Remove the connectors (x4).
• Remove and pull off the lock at the side of the connector insertion part.
• Be careful not to damage the parts on the board.
Otherwise, it will cause malfunction.
* : Symbol indicating the location printed on the board
En-10
(6)
(5)
(7)
(2)
CAUTION
Connector number: CN 5
Connector number: CN 4
Connector number: CN 10
Connector number: CN 7
(4) Remove the wires from the three fixtures. (See the figure below)
• Leave the thick green wire in fixture C and remove the rest of the wires.
• Do not pull the wires forcibly.
You may damage them.
Fixture A
Detail view
Fixture B
Fixture C
(5) While pulling the control box towards you, remove in the right direction.
• Do not remove the thermistor.
• Do not damage the terminals on the removed wires. (See the figure below)
13.3.3. Installing communication box
(1) Install the communication box on the main unit and secure it with the provided
screw at the location shown below.
Motor cover
CAUTION
Before
Thermistor
Control box
Screw
View A (Detail view)
After
Fixture C
Control box
Terminals
(5)
View A (Detail view)
Hide quick links:
Table of Contents
