Configuring E-Aps; Establishing The Configuration Task - Huawei NetEngine80E Configuration Manual - Reliability
Hide thumbs
Also See for NetEngine80E:
- Configuration manual - reliability (1432 pages) ,
- Configuration manual (1301 pages) ,
- Installation manual (169 pages)
Table of Contents
HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
APS Group
------------------------------------------------------------------------
Group
Result
------------------------------------------------------------------------
1
------------------------------------------------------------------------
total entry: 1
Interface Atm-Trunk1's state information is:
Operate status: up
--------------------------------------------------------------------------------
PortName
Atm1/0/1
Atm1/0/2
Display configurations of CPOS-Trunk interfaces.
Interface Cpos-Trunk1's state information is:,
Operate status: up
--------------------------------------------------------------------------------
PortName
Cpos1/0/1
Cpos1/0/2
3.3 Configuring E-APS
Inter-device APS switchback can be performed by configuring E-APS.
3.3.1 Establishing the Configuration Task
Before configuring E-APS, familiarize yourself with the applicable environment, complete the
pre-configuration tasks, and obtain the data required for the configuration. This will help you
complete the configuration task quickly and accurately.
Applicable Environment
E-APS can be configured when the router is connected to an RNC that is dual homed to the
router.
Pre-configuration Task
Before configuring E-APS, complete the following tasks:
l
Data Preparation
To configure E-APS, you need the following data.
No.
1
Issue 02 (2011-09-10)
1: Atm1/0/1 working channel 1(Active)
Atm1/0/2 protection channel 0(Inactive)
Unidirectional, 1+1 mode, Revert time(10 minutes)
No Request on Both Working and Protection Side
Work-Channel
Protect-Channel
Atm1/0/1
Atm1/0/2
Number Of Up Port In Trunk: 2
Status
Active Status
Up
Active
Up
Inactive
Number Of Up Port In Trunk: 2
Status
Active Status
Up
Active
Up
Inactive
Configuring an interface on the router and ensuring that the link layer protocol between the
router and the RNC is Up
Data
ID of an APS group
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Wtr
W-State P-State Switch-Cmd Switch-
10
ok
ok
3 APS Configuration
NA
idle
41
Table of Contents
