Permitting The Bfd To Modify The Pst - Huawei NetEngine80E Configuration Manual - Reliability
Hide thumbs
Also See for NetEngine80E:
- Configuration manual - reliability (1432 pages) ,
- Configuration manual (1301 pages) ,
- Installation manual (169 pages)
Table of Contents
HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Currently, for the NE80E/40E, LDP FRR and IP FRR based on BFD detection need to know
the BFD detection result through the PST.
You do not need to run the
results through the PST.
Pre-configuration Tasks
Before configuring the BFD to modify the PST, complete the task of
hop
Data Preparation
To configure the BFD to modify the PST, you need the following data.
No.
1
5.6.2 Permitting the BFD to Modify the PST
By permitting a BFD session to modify the PST, you can sense the fault detected by the BFD
session through the PST.
Context
Do as follows on the router that learns the BFD results through the PST:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bfd
The BFD session view is displayed.
Step 3 Run:
process-pst
The BFD is permitted to modify the PST.
Issue 02 (2011-09-10)
NOTE
l For the LDP FRR, refer to chapter "MPLS Basic Configuration"in the HUAWEI NetEngine80E/40E
Router Configuration Guide - MPLS.
l IP FRR works for the public network and for the private network. For information about the IP FRR
for the public network, refer to Chapter 10 "Routing Policy Configuration" in the HUAWEI
NetEngine80E/40E Router Configuration Guide - IP Routing.
l For information about the IP FRR for the private network, refer to Chapter 4 "BGP MPLS IP VPN
Configuration" in the HUAWEI NetEngine80E/40E Router Configuration Guide - VPN.
BFD.
Data
Configuration name of the BFD session
cfg-name
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
process-pst
command on the applications that do not learn the BFD
5 BFD Configuration
5.2 Configuring Single-
255
Table of Contents
