Configuring Ethernet Cfm On The Switch And Remote Pe - Huawei NetEngine80E Configuration Manual - Reliability

Hide thumbs Also See for NetEngine80E:
Table of Contents
HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
l
----End

8.13.4 Configuring Ethernet CFM on the Switch and Remote PE

Run Ethernet CFM between the switch and remote PE to check connectivity by exchanging
CCMs. In addition, MAC ping and MAC trace can be performed.
Context
The detailed configuration is similar to that in
and Local
Issue 02 (2011-09-10)
Type of the
Outbound
Interface
Dot1q termination
sub-interface
QinQ termination
sub-interface (in
symmetric mode)
QinQ termination
sub-interface (in
asymmetric mode)
5.
Run:
mep mep-id
mep-id interface { interface-type interface-number | interface-
type interface-number.subnumber } pe-vid pe-vid ce-vid ce-vid outward
An outward-facing MEP is created on the sub-interface for QinQ VLAN tag
termination of the AC interface bound to the L2VC on the PE.
6.
Run:
remote-mep
mep-id mep-id [ mac mac-address ]
An RMEP is created in the MA.
7.
Run:
mep ccm-send
[ mep-id mep-id ] enable
A MEP is enabled to send CCMs.
8.
Run:
remote-mep ccm-receive
The MEP is enabled to receive CCMs from the RMEP in the same MA.
For detailed configurations of the switch, refer to the related configuration guide of the
switch.
PE, and is not mentioned here.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
raw Encapsulation
(Ethernet Encapsulation)
Adds one tag.
Adds the outer tag.
Adds double tags.
[ mep-idmep-id ] enable
8.13.3 Configuring Ethernet CFM on the Switch
8 Ethernet OAM Configuration
tagged Encapsulation
(VLAN Encapsulation)
Replaces the tag with the tag
that is encapsulated on the
outbound interface.
Replaces the outer tag with
the tag that is encapsulated
on the outbound interface.
Removes the outer tag and
then adds two tags that are
encapsulated
443
Table of Contents
loading

This manual is also suitable for:

Netengine40e

Table of Contents