Figure 3-30 Size 4, 5 And 6 Mounting Bracket; Figure 3-31 Orientation Of The Size 4, 5 And 6 Mounting; Figure 3-32 Location Of Top Surface Mounting Brackets; Table 3-1 Mounting Brackets - Emerson unidrive sp User Manual
Universal variable speed ac drive for induction and servo motors model sizes 0 to 6
Hide thumbs
Also See for unidrive sp:
- User manual (268 pages) ,
- User manual (421 pages) ,
- Technical note (6 pages)
Table of Contents
Safety
Product
Mechanical
Information
Information
Installation
3.5.4
Mounting brackets
Table 3-1 Mounting brackets
Model
Surface
size
1
2
3
4
5 & 6
To avoid damaging the through-panel mounting bracket when through-
panel mounting a size 1 or size 2, the through-panel mounting bracket
should be used to mount the top of the drive to the back plate before the
bottom of the drive is mounted to the back plate. The tightening torque
should be 4 N m (2.9 lb ft).
3.5.5
Installation of the mounting bracket on size 4,
5 and 6
Size 4, 5 and 6 use the same mounting brackets for surface and
through-panel mounting.
The mounting bracket has a long section and a short section.
Figure 3-30 Size 4, 5 and 6 mounting bracket
Long section
The mounting bracket must be installed in the correct orientation with the
long section inserted into or attached to the drive and the short section is
attached to the back plate. Figure 3-31 shows the orientation of the
mounting bracket when the drive is surface and through-panel mounted.
Figure 3-31 Orientation of the size 4, 5 and 6 mounting bracket
When through-panel mounted, the mounting brackets on the left hand
side of the drive can be secured using the screws already located there.
On the right hand side, the mounting brackets are just inserted into the
slots in the chassis of the drive; no mounting screws are present here.
Size 5 and 6 also require two top mounting brackets when the drive is
surface mounted. The two brackets should be installed to the top of the
drive as shown in Figure 3-32.
The maximum torque setting for the screws into the drive chassis is
10 N m (7.4 lb ft).
Unidrive SP User Guide
Issue Number: 13
Electrical
Getting
Basic
installation
Started
parameters
Through-panel
x2
x1
x2
x1
x2
x4
x4
x2
Short section
Long section
Short section
www.controltechniques.com
Running
SMARTCARD
Optimization
the motor
operation
Figure 3-32 Location of top surface mounting brackets for size 5 and 6
Hole
size
6.5mm
(0.256in)
8.5mm
(0.335in)
Onboard
Advanced
Technical
Diagnostics
PLC
parameters
Data
UL Listing
Information
47
- Quick Links:
- Trip Indications
Hide quick links:
Chapters
Table of Contents
