Snmp-Agent Target-Host - Huawei Quidway S6500 Series Command Manual
Ethernet switches release 3000 series
Hide thumbs
Also See for Quidway S6500 Series:
- Supplementary manual (5 pages) ,
- Operation manual (647 pages)
Table of Contents
Command Manual - System Management
Quidway S6500 Series Ethernet Switches
5.1.17 snmp-agent target-host
Syntax
snmp-agent target-host trap address udp-domain host-addr [ udp-port
udp-port-number ] params securityname community-string [ v1 | v2c | v3
[ authentication | privacy ] ]
undo snmp-agent target-host host-addr securityname community-string
View
System view
Parameter
trap:Specify the host to receive traps or notifications
address:Specify the transport addresses to be used in the generation of SNMP
messages.
udp-domain:Specify transport domain over UDP for the target address
host-addr: The IP address of destination host.
udp-port udp-port-number: Specify the UDP port number of the host to receive the
SNMP notification.
params:Specify SNMP target information to be used in the generation of SNMP
messages
v1: Represent the version of SNMPV1.
v2c: Represent the version of SNMPV2C.
v3: Represent the version of SNMPV3.
authentication: Configure to authenticate the packet without encryption.
privacy: Configure to authenticate and encrypt the packet.
community-string: Specify the community name. The character string ranges from 1 to
32 bytes.
Description
Using snmp-agent target-host command, you can configure destination of SNMP
notification. Using undo snmp-agent target-host command, you can cancel the host
that receives SNMP notification.
The snmp-agent target-host command and the snmp-agent trap enable command
should be used at the same time. Use the snmp-agent trap enable command to
enable the device to transmit Trap packets. snmp-agent trap enable command and
snmp-agent target-host command should be used at the same time on the host to
enable notify message sending.
Huawei Technologies Proprietary
5-15
Chapter 5 SNMP Configuration Commands
Chapters
Table of Contents
