Toshiba e-STUDIO165 Service Manual page 147
Hide thumbs
Also See for e-STUDIO165:
- Service manual (19 pages) ,
- Operator's manual (162 pages) ,
- User manual (52 pages)
[D] Secondary scanning data laser writing start position
This adjustment has to be performed for each paper source. (If there is no paper source, skip this step.)
The following table shows the order of the paper source to be adjusted, code, paper size and accept-
able values.
Order for
Paper source
adjustment
1
Drawer
2
PFU
3
PFP
4
Bypass feed
5
Duplexing
(1)
While pressing [0] and [5] simultaneously, turn the power ON.
(2)
Press [1]
[FAX]
drawer or 4: PFP lower drawer.)
(3)
Check the grid pattern on the test chart printed out and measure the distance D from the leading
edge of the paper to the 6th line of the grid pattern.
* Normally, the 1st line of the grid pattern is not printed.
(4)
Check if the distance D is within 50±0.5 mm.
(5)
If not, use the following procedure to change values and measure the distance D again.
(Adjustment Mode)
(Key in an acceptable value shown above)
[ENTER] (Stored in memory)
Press [1]
[FAX]
(A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance D becomes (approx. 0.4 mm/step).
© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Code
Paper size
440
A3/LD
441
A4/LT
444
A4/LT
442
A4/LT
445
A3/LD
[Drawer number] (Select from 0: bypass, 1: drawer, 2: PFU, 3: PFP upper
[START]. (A grid pattern with 10 mm squares is printed out.)
(Key in the code shown above)
[CANCEL]
Press [Drawer number]
3 - 9
06/04
Acceptable
value
0 to 40
0 to 40
0 to 15
0 to 15
0 to 15
Paper fed from the drawer
(Adjustment Mode)
[ENTER]
"MC" is displayed
[START]
Remarks
e-STUDIO165/167/205/207/237
ADJUSTMENT
3
Hide quick links:
Troubleshooting
